Whirlpool WFW3090GW Installation Guide - Page 20
Installation Instructions, Electrical Requirements
View all Whirlpool WFW3090GW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Electrical Requirements Installation Instructions NOTE: To avoid floor damage, set washer onto cardboard before moving it. 1. Move washer n A 120-volt, 60 Hz., AC-only, 15- or 20-amp, fused electrical supply is required. A time-delay fuse or circuit breaker is recommended. It is recommended that a separate circuit breaker serving only this appliance be provided. n This washer is equipped with a power supply cord having a 3 prong grounding plug. n To minimize possible shock hazard, the cord must be plugged into a mating, 3 prong, grounding-type outlet, grounded in accordance with local codes and ordinances. If a mating outlet is not available, it is the personal responsibility and obligation of the customer to have the properly grounded outlet installed by a qualified electrician. n If codes permit and a separate ground wire is used, it is recommended that a qualified electrician determine that the ground path is adequate. n Do not ground to a gas pipe. n Check with a qualified electrician if you are not sure the washer is properly grounded. n Do not have a fuse in the neutral or ground circuit. 48" (1.2 m) It is necessary to remove all shipping materials for proper operation and to avoid excessive noise from washer. Move washer to within 48" (1.2 m) of its final location. It must be in a fully upright position. 2. Remove transport bolts from washer Loosen bolts with a 3/8" (10 mm) wrench. Once the bolt is loose, wiggle and completely pull out the bolt and shipping plug. 20