Whirlpool WFW5090JW Dimension Guide - Page 2

ELECTRICAL REQUIREMENTS A 120 volt, 60 Hz., AC only, 15- or 20-amp, fused electrical supply is required. A time-delay fuse or circuit breaker is recommended. It is recommended that a separate circuit breaker serving only this appliance be provided. Location Requirements (cont.) Closet installation (washer only): Laundry tub drain system 1384"" (485674 mm) 3" (76 mm) 48 in.2 min. (310 cm2) 41/2" (114 mm) max. 49" (1(122550 cmmm) ) min. 24" ((6600 mcmm)) 4" * (102 mm) 24 in.2 min. (155 cm2) 3" (76 mm) 1"* 1"* (25 mm) (25 mm) Drain System *Recommended spacing. Minimum 0" (0 mm) Drain system can be installed using a floor drain, wall standpipe, floor standpipe, or laundry tub. Select method you need. IMPORTANT: To avoid siphoning, only 41⁄2" (114 mm) of drain hose should be inside standpipe. Always secure drain hose with cable tie. Floor standpipe drain system Minimum capacity: 20 gal. (76 L). Top of laundry tub must be at least 24" (60 cm) above floor; install no higher than 49" (125 cm) from bottom of washer. Floor drain system Floor drain system requires a Siphon Break Kit (Part Number 285834), 2 Connector Kits (Part Number 285835), and an Extension Drain Hose (Part Number 285863) that may be purchased separately. See "Alternate Parts." Minimum siphon break height: 28" (710 mm) from bottom of washer. (Additional hoses may be needed.) 441./52"" (114 mm) max. 489" (1(122159 cmmm) ) min. 3204" (7(602 cmmm) ) Minimum diameter for a standpipe drain: 2" (51 mm). Minimum carryaway capacity: 17 gal. (64 L) per minute. A 1/4" (6 mm) diameter to 1" (25 mm) diameter Standpipe Adapter Kit is available (Part Number 3363920). Top of standpipe must be at least 24" (60 cm) high; install no higher than 49" (125 cm) from bottom of washer. If you have an overhead sewer and need to pump higher than 96 inches, a sump pump and associated hardware are needed. See "Alternate Parts." Wall standpipe drain system 41/2" (114 mm) max. 49" (1(122550 cmmm) ) min. 24" ((6600 mcmm)) See requirements for floor standpipe drain system. Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice. Dimensions are for planning purposes only. For complete details, see Installation Instructions packed with product. Specifications subject to change without notice.