Whirlpool WFW72HEDW Installation Guide - Page 3

Location Requirements - dimensions

Get Whirlpool WFW72HEDW PDF manuals and user guides View all Whirlpool WFW72HEDW manuals
Add to My Manuals
Save this manual to your list of manuals

Page 3 highlights

LOCATION REQUIREMENTS Proper installation is your responsibility. You will need: n A water heater set to 120° F (49° C). n A grounded electrical outlet located within 6 ft (1.8 m) of power cord on back of washer. n Hot and cold water faucets located within 4 ft (1.2 m) of hot and cold water fill valves on washer, and water pressure of 20-100 psi (137.9-689.6 kPa). n A level floor with maximum slope of 1" (25 mm) under entire washer. Installing on carpet or surfaces with foam backing is not recommended. n Floor must support washer's total weight (with water and load) of 315 lbs (143 kgs). IMPORTANT: Do not install, store or operate washer where it will be exposed to weather or in temperatures below 32° F (0° C). Water remaining in washer after use may cause damage in low temperatures. See "Washer Care" in your "Use and Care Guide" for winterizing information. Whirlpool Models* 523/4" (1340 mm) 335/16" (846 mm) 27" (686 mm) Maytag Models 5215/16" (1345 mm) 3215/16" (837 mm) 27" (686 mm) 383/4" - 393/4" (948 mm - 1010 mm) All dimensions show recommended spacing allowed, except for closet door ventilation openings which are the minimum required. For each arrangement, consider allowing more space for ease of installation and servicing, and spacing for companion appliances and clearances for walls, doors, and floor moldings. Space must be large enough to allow door to fully open. Add spacing of 1" (25 mm) on all sides of washer to reduce noise transfer. If a closet door or louvered door is installed, top and bottom air openings in door are required. Recessed area or closet installation (stacked washer and dryer): 3" (76 mm) 6" (152 mm) 383/4" - 393/4" (948 mm - 1010 mm) 523/4" (1340 mm) 331/8" (841 mm) 27" (686 mm) 383/4" - 393/4" (948 mm - 1010 mm) 48 in.2 (310 cm2) 761/2" (1943 mm) 24 in.2 (155 cm2) 3" 1"* (76 mm) (25 mm) 5" (127 mm) * Add spacing of 1" (25 mm) on all sides of washer/dryer. Custom under counter installation: * For additional details (or information) specific to your model, refer to the Dimension Guide at www.whirlpool.com. 3

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
3
LOCATION REQUIREMENTS
Proper installation is your responsibility.
You will need:
n
A water heater set to 120° F (49° C).
n
A grounded electrical outlet located within 6 ft (1.8 m) of
power
cord on back of washer.
n
Hot and cold water faucets located within 4 ft (1.2 m) of hot
and cold water fill valves on washer, and water pressure of
20-100 psi (137.9-689.6 kPa).
n
A level floor with maximum slope of 1" (25 mm) under entire
washer. Installing on carpet or surfaces with foam backing is
not recommended.
n
Floor must support washer’s total weight (with water and load)
of 315 lbs (143 kgs).
IMPORTANT:
Do not install, store or operate washer where it will
be exposed to weather or in temperatures below 32° F (0° C).
Water remaining in washer after use may cause damage in low
temperatures. See “Washer Care” in your “Use and Care Guide”
for winterizing information.
Whirlpool Models*
38
3
/
4
" - 39
3
/
4
"
(948 mm - 1010 mm)
27"
(686 mm)
33
5
/
16
"
(846 mm)
52
3
/
4
"
(1340 mm)
Maytag Models
38
3
/
4
" - 39
3
/
4
"
(948 mm - 1010 mm)
27"
(686 mm)
52
3
/
4
"
(1340 mm)
33
1
/
8
"
(841 mm)
38
3
/
4
" - 39
3
/
4
"
(948 mm - 1010 mm)
27"
(686 mm)
32
15
/
16
"
(837 mm)
52
15
/
16
"
(1345 mm)
All dimensions show recommended spacing allowed, except for
closet door ventilation openings which are the minimum required.
For each arrangement, consider allowing more space for ease of
installation and servicing, and spacing for companion appliances
and clearances for walls, doors, and floor moldings.
Space must be large enough to allow door to fully open.
Add spacing of 1" (25 mm) on all sides of washer to reduce
noise transfer. If a closet door or louvered door is installed, top
and bottom air openings in door are required.
76
1
/
2
"
(1943 mm)
5"
(127 mm)
6"
(152 mm)
1"
(25 mm)
24 in.
2
(155 cm
2
)
48 in.
2
(310 cm
2
)
3"
(76 mm)
6"
(152 mm)
3"
(76 mm)
Recessed area or closet installation
(stacked washer and dryer):
Custom under counter installation:
* For additional details (or information) specific to your model,
refer to the Dimension Guide at www.whirlpool.com.
*
Add spacing of 1" (25 mm) on all sides of washer/dryer.
*