Whirlpool WFW9151YW Installation Guide - Page 6

3. Remove transport bolts from washer 6. Place power cord over top Loosen bolts with a 13 mm (1/2") wrench. Slide each bolt and spacer to center of hole. Pull bolts and plastic spacers from back of washer. Save transport bolts and spacers. Contact a qualified servicer if washer is to be transported. 4. Cover bolt holes with transport bolt hole plugs Gently place power cord over top of washer to allow free access to back of washer. CONNECT DRAIN HOSE 7. Attach drain hose to drain port Close bolt holes on cabinet back with transport bolt hole plugs included with washer parts. 5. Remove power cord Pull power cord through opening in rear panel and close holes (2) with attached white plastic cap. NOTE: If washer is transported at a later date, call a certified technician to properly set up washer for relocation, to avoid suspension and structural damage. 6 Squeeze hose clamp tabs with pliers and slide over end of drain hose. Slide drain hose onto washer elbow connector and secure with clamp. For a laundry tub or standpipe drain, go to step 8. You may need additional parts with separate directions. See Floor drain system under "Alternative Parts".