Whirlpool WFW92HEFU Installation Guide - Page 4
Drain System
View all Whirlpool WFW92HEFU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Recessed area or closet installation (washer only): 3" (76 mm) 48 in.2 (310 cm2) Custom cabinet installation: 7" (178 mm) 14" (356 mm) 24 in.2 (155 cm2) 3" 1" * (76 mm) (25 mm) 4" ** (102 mm) 1" * (25 mm) 4" ** (102 mm) * Add spacing of 1" (25 mm) on all sides of washer. ** Recommended 4" (102 mm), minimum 1.5" (38 mm) DRAIN SYSTEM Drain system can be installed using a floor drain, wall standpipe, floor standpipe, or laundry tub. Select method you need. IMPORTANT: To avoid siphoning, only 4.5" (114 mm) of drain hose should be inside standpipe. Always secure drain hose with cable tie. Floor standpipe drain system Laundry tub drain system 4.5" (114 mm) Minimum diameter for a standpipe drain: 2" (51 mm). Minimum carry-away capacity: 17 gal. (64 L) per minute. A 1/4" (6 mm) diameter to 1" (25 mm) diameter Standpipe Adapter Kit is available (Part Number 3363920). Top of standpipe must be at least 30" (762 mm) high; install no higher than 96" (2.44 m) from bottom of washer. If you have an overhead sewer and need to pump higher than 96" (2.44 m), a sump pump and associated hardware are needed. See "Alternate Parts". Wall standpipe drain system 4.5" (114 mm) min. 30" (762 mm) Minimum capacity: 20 gal. (76 L). Top of laundry tub must be at least 30" (762 mm) above floor; install no higher than 96" (2.44 m) from bottom of washer. Floor drain system 4.5" (114 mm) See requirements for floor standpipe drain system. 4 Floor drain system requires a Siphon Break Kit (Part Number 285834), 2 Connector Kits (Part Number 285835), and an Extension Drain Hose (Part Number 285863) that may be purchased separately. See "Alternate Parts". Minimum siphon break height: 28" (710 mm) from bottom of washer. (Additional hoses may be needed.)