Whirlpool WFW92HEFU Installation Guide - Page 8
Level Washer
View all Whirlpool WFW92HEFU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
13. Connect inlet hoses to washer LEVEL WASHER Leveling your washer properly reduces excess noise and vibration. 16. Check levelness of washer Place level here Attach hot water hose to hot water inlet valve. Screw coupling by hand until it is snug. Use pliers to tighten couplings an additional two-thirds turn. Repeat with cold water inlet valve. IMPORTANT: Do not overtighten or use tap or sealants on valve when attaching to faucets or washer. Damage can result. NOTE: To reduce risk of hose failure, replace the hoses every 5 years. Record hose installation or replacement dates for future reference. n Periodically inspect and replace hoses if bulges, kinks, cuts, wear, or leaks are found. 14. Check for leaks Remove cardboard from beneath washer. Place a level on top edges of washer, checking each side and front. If not level, tip washer and adjust feet up or down as shown in steps 18 and 19, repeating as necessary. Not Level LEVEL Not Level 17. Rock washer to test foot contact Slowly turn on water faucets to check for leaks. A small amount of water may enter washer. It will drain later. 15. Secure drain hose Laundry Tub Standpipe Wall 4.54".5" (114 mm) 4.5" (114 mm) 4.5" (1143 mm) Grip washer from top and rock back and forth, making sure all four feet are firmly on floor. Repeat, rocking washer from side to side. If washer rocks, go to step 18 and adjust leveling feet. If all four feet are in firm contact with floor, go to Step 19. Secure drain hose to laundry tub leg, drain standpipe, or inlet hoses for wall standpipe with cable tie. 8