Whirlpool WFW9750WW Owners Manual - Page 5

Location Requirements Selecting the proper location for your washer improves  performance and minimizes noise and possible washer "walk." Your washer can be installed under a custom counter, or in a basement, laundry room, closet, or recessed area. See "Drain System." Companion appliance location requirements should also  be considered. Proper installation is your responsibility. You will need ■ A water heater set to deliver 120°F (49°C) water to the  washer. Recommended installation spacing for custom undercounter installation The dimensions shown are for the recommended spacing. Custom undercounter installation - Washer only 39" min. (990 mm) ■ A grounded electrical outlet located within 6 ft (1.8 m) of  where the power cord is attached to the back of the washer.  See "Electrical Requirements." ■ Hot and cold water faucets located within 4 ft (1.2 m)  of the hot and cold water fill valves, and water pressure  of 20-100 psi (137.9-689.6 kPa). ■ If you live in a hard water area, use of a water softener is recommended to control the buildup of scale in the steamer  and other areas of the washer. Over time, the buildup of lime scale may clog the steamer, which will reduce steamer  efficiency and performance. Excessive buildup of scale may lead to the need for steamer replacement or repair. ■ A level floor with a maximum slope of 1" (25 mm) under entire washer. Installing the washer on soft floor surfaces, such as carpets or surfaces with foam backing, is not recommended. 1" (25 mm) 27" (686 mm) 1" (25 mm) Recommended installation spacing for recessed  or closet installation, with or without a pedestal The dimensions shown are for the recommended spacing. Recessed area or closet installation 34" 48 in.2 * (864 mm) (310 cm2) 3" (76 mm) ■ A sturdy and solid floor to support the washer with a total weight (water and load) of 400 lbs (180 kg). Do not operate your washer in temperatures below 32°F (0°C). Some water can remain in the washer and can cause damage in low temperatures. Installation clearances ■ The location must be large enough to allow the washer door  to be fully opened. ■ Additional spacing should be considered for ease of installation and servicing. 24 in.2 * (155 cm2) 1" 31½" 4" (25 mm) (800 mm) (102 mm) 3" (76 mm) A B A. Side view - closet or confined area B. Closet door with vents *Min. top and bottom air openings for closet door. Recessed or closet installation - Washer on pedestal ■ Additional clearances might be required for wall, door, and  floor moldings. ■ Additional spacing of 1" (25 mm) on all sides of the washer  is recommended to reduce noise transfer. 18" min. (457 mm) ■ Companion appliance spacing should also be considered. Washer Dimensions 521/2" (1335 mm) 27" (686 mm) 1" (25 mm) 27" (686 mm) A 1" (25 mm) 1" 31½" 4" (25 mm)(800 mm)(102 mm) B 381/4" (970 mm) A. Recessed area B. Side view - closet or confined area 321/2" (820 mm) 5