Whirlpool WGD4800BQ Installation Guide - Page 15

5. Remove screws from door 8. Flip door over Remove screws at top, bottom, and side of door (4 screws) that hold the inner and outer door together. Holding door over towel on dryer, grasp sides of outer door and lift to separate it from inner door. Set outer door aside. NOTE: Do not pry apart with putty knife or screwdriver. Do not pull on door seal or plastic door catches. 6. Switch door catch, bezel, & plug Flip door over so handle side is down. 9. Attach door hinges Catch and bezel Plug Remove the door catch, bezel, and plug from the inside of the inner door by squeezing and pulling/pushing them. Place the door catch, bezel, and plug on the sides opposite from where they were. 7. Rotate outer door Reattach door hinges to dryer door so that the larger hole is at the bottom of the hinge. Rotate outer door 180º and set it back down on inner door. Reattach outer door panel to inner door panel so handle is on the side where hinges were just removed. Insert 4 door screws. 15