Whirlpool WGD9600TA Installation Instructions - Page 4

In the State of Massachusetts, the following installation instructions apply: ■ Installations and repairs must be performed by a qualified or licensed contractor, plumber, or gasfitter qualified or licensed by the State of Massachusetts. ■ If using a ball valve, it shall be a T-handle type. ■ A flexible gas connector, when used, must not exceed 3 feet. INSTALLATION REQUIREMENTS Tools and Parts Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. For All Installations: Steam Models ■ Flat-blade screwdriver ■ #2 Phillips screwdriver ■ Adjustable wrench that opens to 1" (25 mm) or hex-head socket wrench (for adjusting dryer feet) ■ Level ■ Vent clamps ■ Caulking gun and compound (for installing new exhaust vent) ■ Tin snips (new vent installations) ■ ¼" nut driver (recommended) ■ Tape measure ■ Pliers Gas Installations: ■ 8" or 10" pipe wrench ■ Pipe-joint compound ■ 8" or 10" adjustable wrench resistant to LP gas (for gas connections) Parts supplied Non-Steam Models 4 Leveling legs A B A. Leveling legs (4) B. "Y" connector C. Short inlet hose C D E D. Inlet hose with right-angle connector E. Rubber washer Remove parts package from dryer drum. Check that all parts are included. NOTE: Do not use leveling legs supplied with dryer if installing on a pedestal. Parts needed Check local codes. Check existing electrical supply and venting. See "Electrical Requirements" and "Venting Requirements" before purchasing parts. Mobile home installations require metal exhaust system hardware available for purchase from the dealer from whom you purchased your dryer. For further information, please refer to the "Assistance or Service" section in your Use and Care Guide. Optional Equipment Refer to your Use and Care guide for information about the accessories available for your dryer. 4