Whirlpool WGE755C0BH Installation Guide - Page 8
Style 2: Direct wire strain relief, Electrical Connection Options, If your home has, And you will
View all Whirlpool WGE755C0BH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Style 2: Direct wire strain relief ■ Use Phillips screwdriver to remove screws and slide cord/conduit plate down and out. ■ Feed the flexible conduit through the strain relief, allowing enough slack to easily attach wiring to the terminal block. ■ Tighten strain relief screw against the flexible conduit. ■ Position cord/conduit plate as shown in the following illustration. ■ Replace cord/conduit plate and insert screws. ■ Assemble a UL listed conduit connector in the opening. 5. Replace back panel and screws on rear of range. 6. Complete installation following instructions for your type of electrical connection: 4-wire (recommended) 3-wire (if 4-wire is not available) Electrical Connection Options If your home has: And you will be Go to Section: connecting to: 4-wire receptacle (NEMA type 14-50R) A UL listed, 250-volt minimum, 40-amp, range power supply cord 4-wire connection: Power supply cord 4-wire direct 5" (12.7 cm) 3-wire receptacle (NEMA type 10-50R) A fused disconnect or circuit breaker box A UL listed, 250-volt minimum, 40-amp, range power supply cord 4-wire connection: Direct wire 3-wire connection: Power supply cord 3-wire direct 1" (2.5 cm) 3" (7.6 cm) A fused disconnect or circuit breaker box 3-wire connection: Direct wire A B A. Removable retaining nut B. Strain relief 8