Whirlpool WGT3300XQ Installation Guide - Page 9

ELECTRICAL REQUIREMENTS GAS SUPPLY REQUIREMENTS n This washer/dryer is equipped with a power supply cord having a 3-prong grounding plug. n To minimize possible shock hazard, the cord must be plugged into a mating, 3-prong, grounding-type outlet, grounded in accordance with local codes and ordinances. If a mating outlet is not available, it is the personal responsibility and obligation of the customer to have the properly grounded outlet installed by a qualified electrician. n If codes permit and a separate ground wire is used, it is recommended that a qualified electrician determine that the ground path is adequate. n Do not ground to a gas pipe. n Check with a qualified electrician if you are not sure the washer is properly grounded. n Do not have a fuse in the neutral or ground circuit. n 120 Volt, 60 Hz, AC only, 15- or 20- amp fused electrical supply is required. A time-delay fuse or circuit breaker is recommended. It is also recommended that a separate circuit serving only this washer/dryer be provided. GAS TYPE Natural Gas: This washer/dryer is equipped for use with Natural gas. It is design-certified by CSA International for LP (propane or butane) gases with appropriate conversion. ■■ Your washer/dryer must have the correct burner for the type of gas in your home. Burner information is located on the rating plate in the door well of your dryer. If this information does not agree with the type of gas available, contact your dealer or call the phone numbers referenced in the "Assistance or Service" section of your Use and Care Guide. LP Gas Conversion: IMPORTANT: Conversion must be made by a qualified technician. No attempt shall be made to convert the appliance from the gas specified on the model/serial rating plate for use with a different gas without consulting your gas company. 9