Whirlpool WOEC5030LZ Owners Manual - Page 17

Complete Installation, If Ovens Does Not Operate, Check the Following

Page 17 highlights

6. Locate the oven door hinge locks in the corners of the oven door, and rotate the hinge locks toward the oven cavity to the locked position. A. Unlocked position B. Locked position 7. After the door hinges have been locked, gently swing the door upward to close. The door should not be forced closed. 8. When the hinges are properly installed and the door is closed, there should be an even gap between the door and the control panel. If one side of the oven door is lower than the other, the hinge on that side is not properly installed. Complete Installation 1. Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped. 2. Check that you have all of your tools. 3. Dispose of/recycle all packaging materials. 4. For oven cleaning, read the "Oven Maintenance and Care" section. Check Operation of Single and Double Ovens 1. Turn on power. 2. At first use, set up the languages, clock, and any other preferences, if available. For more information, read the online "Control Guide". 3. Start a broil cycle. NOTE: Odors and smoke are normal when the oven is used the first few times. 4. Wait 5 minutes, then check for heat. If Oven(s) Does Not Operate, Check the Following: � Household fuse is intact and tight; or circuit breaker has not tripped. � Electrical supply is connected. � See the online "Troubleshooting". 5. Place the SatinGlide™ Roll-Out Extension Rack for Smart Oven+ Attachments in the lowest rack position in the unit to make sure the correct accessory rack is on the bottom. 6. Press UPPER CANCEL/LOWER CANCEL on double ovens, or press CANCEL on single ovens. If you need Assistance or Service: Please refer to the Quick Start Guide for contact information. Check Operation of Microwave Oven 1. Fill a microwave-safe container with 1 cup (250 mL) of water and place container inside microwave oven. Close door firmly. 2. Press MICROWAVE. 3. Select Cooking Method. 4. Set microwave oven cook time to 2 minutes. 5. Press START. The interior microwave oven light should be on, and the remaining cooking time should be displayed. When display reads "1:00", open microwave oven door. The microwave should stop cooking. Close door firmly. The interior microwave oven light should turn off. 6. Press START. Microwave oven should begin cooking, and the microwave oven interior light should be on. Let microwave oven complete cooking time. A tone will sound four times at the end of the cooking time, and the microwave oven will shut off. 7. Open microwave oven door and slowly remove container. Water in container should be hot. If you need Assistance or Service: Please refer to the Quick Start Guide for contact information, or contact the dealer from whom you purchased your built-in electric ovens and microwave ovens. 17

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56

17
6.
Locate the oven door hinge locks in the corners of the oven
door, and rotate the hinge locks toward the oven cavity to the
locked position.
A.
Unlocked
position
B.
Locked position
7.
After the door hinges have been locked, gently swing the door
upward to close. The door should not be forced closed.
8.
When the hinges are properly installed and the door is closed,
there should be an even gap between the door and the control
panel. If one side of the oven door is lower than the other, the
hinge on that side is not properly installed.
Complete Installation
1.
Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
2.
Check that you have all of your tools.
3.
Dispose of/recycle all packaging materials.
4.
For oven cleaning, read the “Oven Maintenance and Care”
section.
Check Operation of Single and Double Ovens
1.
Turn on power.
2.
At first use, set up the languages, clock, and any other
preferences, if available. For more information, read the online
“Control Guide”.
3.
Start a broil cycle.
NOTE:
Odors and smoke are normal when the oven is used
the first few times.
4.
Wait 5 minutes, then check for heat.
If Oven(s) Does Not Operate, Check the Following:
Household fuse is intact and tight; or circuit breaker has
not tripped.
Electrical supply is connected.
See the online “Troubleshooting”.
5.
Place the SatinGlide
Roll-Out Extension Rack for Smart
Oven+ Attachments in the lowest rack position in the unit to
make sure the correct accessory rack is on the bottom.
6.
Press UPPER CANCEL/LOWER CANCEL on double ovens,
or press CANCEL on single ovens.
If you need Assistance or Service:
Please refer to the Quick Start Guide for contact information.
Check Operation of Microwave Oven
1.
Fill a microwave-safe container with 1 cup (250 mL) of water
and place container inside microwave oven. Close door firmly.
2.
Press MICROWAVE.
3.
Select Cooking Method.
4.
Set microwave oven cook time to 2 minutes.
5.
Press START. The interior microwave oven light should be on,
and the remaining cooking time should be displayed.
When display reads “1:00”, open microwave oven door. The
microwave should stop cooking. Close door firmly. The interior
microwave oven light should turn off.
6.
Press START. Microwave oven should begin cooking, and the
microwave oven interior light should be on.
Let microwave oven complete cooking time. A tone will sound
four times at the end of the cooking time, and the microwave
oven will shut off.
7.
Open microwave oven door and slowly remove container.
Water in container should be hot.
If you need Assistance or Service:
Please refer to the Quick Start Guide for contact information, or
contact the dealer from whom you purchased your built-in electric
ovens and microwave ovens.