Whirlpool WRF560SEHZ Owners Manual - Page 11

Door Closing and Door Alignment IMPORTANT: To comply with American Disabilities Act (ADA) guidelines, fully retract the rollers into the cabinet to lower the refrigerator. ■ Push the base grille in toward the refrigerator until it is firmly in place. Door Closing The base grille covers the leveling screws and roller assemblies located at the bottom of the refrigerator cabinet below the freezer drawer. Before making adjustments, remove the base grille and move the refrigerator to its final location. 1. Remove the base grille. Grasp the grille firmly and pull it toward you. 2. Move the refrigerator to its final location. NOTE: To allow the refrigerator to roll easier, raise the leveling legs off the floor by turning the leveling screws counterclockwise. The front rollers will be touching the floor. 3. So the doors will close easier, use a ¹⁄₄" hex driver to turn both leveling screws clockwise. This will raise the front of the refrigerator tilting it slightly downward to the rear. Turn both leveling screws the same amount. NOTE: Having someone push against the top of the refrigerator takes some weight off the leveling screws. This makes it easier to turn the screws. ¹⁄₄" A B A. Tab B. Clip Door Alignment If the space between the refrigerator doors and freezer drawer looks uneven, you can adjust it using the following instructions: 1. Remove the top hinge cover. 2. Loosen the top hinge screws using a socket or wrench. 3. Have someone hold the door in place or put a spacer between the doors and drawer. 4. Tighten the top hinge screws once the door is in the desired location. 5. Replace the top hinge cover. A B A. Leveling screw B. Front roller 4. Open both doors again to make sure they close as easily as you like and that they stay closed. If not, tilt the refrigerator slightly more to the rear by turning both leveling screws to the right. It may take several more turns. NOTE: To keep the refrigerator level, you should turn both leveling screws the same amount. 5. Replace the base grille. ■ Pull open the freezer drawer. ■ Align the 3 clips on the back of the base grille with the 3 tabs at the base of the refrigerator. FILTERS AND ACCESSORIES Water Filtration System Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts. Water Filter Status Light The water filter status light on the control panel will help you know when to order and replace the water filter. ■ GOOD - The water filter icon on the control lights up in BLUE. ■ ORDER a replacement filter - The water filter icon on the control lights up in YELLOW. ■ REPLACE the water filter - The water filter icon on the control lights up in RED and "Replace Filter" will appear on the display. ■ EXPIRED - The water filter icon lights up in RED and "Replace Filter" flashes on the display. NOTE: If water flow to your water dispenser or ice maker decreases noticeably, change the filter sooner. The disposable water filter should be replaced at least every 6 months, depending on your water quality and usage. ■ After changing the water filter, reset the status. Press and hold the Water Filter button for 3 seconds. When the system is reset, the water filter icon will return to BLUE and the words "Replace Filter" will disappear from the display. 11