Whirlpool WRF767SDEM Use & Care Guide - Page 36

Doors

Get Whirlpool WRF767SDEM PDF manuals and user guides View all Whirlpool WRF767SDEM manuals
Add to My Manuals
Save this manual to your list of manuals

Page 36 highlights

TR O U B L E S H O O T I N G PROBLEM POSSIBLE CAUSES SOLUTIONS The ice dispenser Crushed ice is blocking the ice delivery Switch from crushed ice to cubed ice to clear the ice dispenser. jams while dispensing chute. Then switch back to crushed ice. crushed ice Water is leaking or dripping from the dispenser system NOTE: A few drops of water after dispensing is normal. The glass was not held under the dispenser long enough. Hold the glass under the dispenser 2 to 3 seconds after releasing the dispenser lever. Water continues to drip from the dispenser beyond the first few drops. The refrigerator has just been installed. The water filter was recently installed or replaced. Flushing the water system removes the air from the lines which causes the water dispenser to drip. Flush the water system. See "Water and Ice Dispensers." Flushing the water system removes the air from the lines which causes the water dispenser to drip. Flush the water system. See "Water and Ice Dispensers." Water is leaking from the back of the refrigerator The water line connections were not fully tightened. See "Connecting the Water." Recently removed the doors and did not See "Remove and Replace Refrigerator Doors." fully tighten water line connection Water from the dispenser is warm Water from the dispenser is chilled to 50°F (10°C). This is normal. The refrigerator has just been installed. Allow 24 hours after installation for the water supply to cool completely. A large amount of water was recently dispensed. Allow 3 hours for the water supply to cool completely. Water has not been recently dispensed. The first glass of water may not be cool. Discard the first glass of water dispensed. The refrigerator is not connected to a cold water pipe. Make sure the refrigerator is connected to a cold water pipe. See "Water Supply Requirements." Doors WARNING Explosion Hazard Use nonflammable cleaner. Failure to do so can result in death, explosion, or fire. To view an animation showing how to adjust and align the doors, refer to the Product Help/FAQ section of the brand website and search for "door closing and door alignment." PROBLEM POSSIBLE CAUSES SOLUTIONS The doors will not close completely The door is blocked open. A bin or shelf is in the way. Move food packages away from door. Push bin or shelf back into the correct position. Recently installed Remove all packaging materials. 36

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
36
TROUBLESHOOTING
Doors
To view an animation showing how to adjust and align the doors, refer to the Product Help/FAQ section of the brand website and search
for “door closing and door alignment.”
The ice dispenser
jams while dispensing
crushed ice
Crushed ice is blocking the ice delivery
chute.
Switch from crushed ice to cubed ice to clear the ice dispenser.
Then switch back to crushed ice.
Water is leaking or
dripping from the
dispenser system
NOTE:
A few drops of
water after dispensing
is normal.
The glass was not held under the
dispenser long enough.
Hold the glass under the dispenser 2 to 3 seconds after releasing
the dispenser lever.
Water continues to
drip from the
dispenser beyond the
first few drops.
The refrigerator has just been installed.
Flushing the water system removes the air from the lines which
causes the water dispenser to drip. Flush the water system.
See “Water and Ice Dispensers.”
The water filter was recently installed or
replaced.
Flushing the water system removes the air from the lines which
causes the water dispenser to drip. Flush the water system.
See “Water and Ice Dispensers.”
Water is leaking from
the back of the
refrigerator
The water line connections were not
fully tightened.
See “Connecting the Water.”
Recently removed the doors and did not
fully tighten water line connection
See “Remove and Replace Refrigerator Doors.”
Water from the
dispenser is warm
Water from the dispenser is chilled to
50°F (10°C).
This is normal.
The refrigerator has just been installed.
Allow 24 hours after installation for the water supply to cool
completely.
A large amount of water was recently
dispensed.
Allow 3 hours for the water supply to cool completely.
Water has not been recently dispensed.
The first glass of water may not be cool. Discard the first glass of
water dispensed.
The refrigerator is not connected to a
cold water pipe.
Make sure the refrigerator is connected to a cold water pipe. See
“Water Supply Requirements.”
PROBLEM
POSSIBLE CAUSES
SOLUTIONS
The doors will not close
completely
The door is blocked open.
Move food packages away from door.
A bin or shelf is in the way.
Push bin or shelf back into the correct position.
Recently installed
Remove all packaging materials.
PROBLEM
POSSIBLE CAUSES
SOLUTIONS
WARNING
Explosion Hazard
Use nonflammable cleaner.
Failure to do so can result in death, explosion, or fire.