Whirlpool WRTX5028PB Owners Manual - Page 3
MAINTENANCE AND CARE, Cleaning, Changing the Light Bulbs, WARNING
View all Whirlpool WRTX5028PB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
MAINTENANCE AND CARE Cleaning WARNING 4. There is no need for routine condenser cleaning in normal home operating environments. If the environment is particularly greasy or dusty, or there is a significant pet traffic in the home, the condenser should be cleaned every 2 to 3 months to ensure maximum efficiency. If you need to clean the condenser: WARNING Explosion Hazard Risk of Fire or Explosion. Flammable Refrigerant Used. Do Not Use Mechanical Devices to Defrost Refrigerator. Do Not Puncture Refrigerant Tubing. Both the refrigerator and freezer sections defrost automatically. However, clean both sections about once a month to avoid buildup of odors. Wipe up spills immediately. IMPORTANT: � Because air circulates between both sections, any odors formed in one section will transfer to the other. You must thoroughly clean both sections to eliminate odors. To avoid odor transfer and drying out of food, wrap or cover foods tightly � For stainless steel models, stainless steel is corrosion resistant and not corrosion-proof. To help avoid corrosion of your stainless steel, keep your surfaces clean by using the following cleaning instructions To Clean Your Refrigerator: NOTE: Do not use abrasive or harsh cleaners such as window sprays, scouring cleansers, flammable fluids, muriatic acid, cleaning waxes, concentrated detergents, bleaches or cleansers containing petroleum products on exterior surfaces (doors and cabinet), plastic parts, interior and door liners, or gaskets. Do not use paper towels, scouring pads, or other harsh cleaning tools. 1. Unplug refrigerator or disconnect power. 2. Using a clean sponge or soft cloth and a mild detergent in warm water, hand-wash, and rinse removable parts and interior surfaces thoroughly. Dry thoroughly with a soft cloth. 3. Clean the exterior surfaces. IMPORTANT: � When cleaning stainless steel, always wipe in the direction of the grain to avoid cross-grain scratching. � To keep your stainless steel refrigerator looking like new and to remove minor scuffs or marks, it is suggested that you use the manufacture's approved Stainless Steel Cleaner and Polish. To order, use the following parts: Affresh® Stainless Steel Cleaner: Part #W10355016 Affresh® Stainless Steel Wipes: Part #W10355049 Affresh® Kitchen & Appliance Cleaner: Part #W10355010 � Stainless Steel Cleaner and Polish is for stainless steel only. Do not allow the Stainless Steel Cleaner to come into contact with any plastic parts such as the trim pieces, dispenser covers or door gaskets. If unintentional contact does occur, clean plastic part with a sponge and a mild detergent in warm water. Dry thoroughly with a soft cloth. Explosion Hazard Risk of Fire or Explosion due to Puncture of Refrigerant Tubing; Follow Handling Instructions Carefully. Flammable Refrigerant Used. � Pull refrigerator out away from the wall. See "Unpack the Refrigerator." � Remove the base grille. � Vacuum coils when they are dusty or dirty. � Replace the base grille when finished. � Roll refrigerator back into place. Make sure to leave 1" (2.5 cm) between the cabinet back and the wall. � Check to see that the refrigerator is level. 5. Plug in refrigerator or reconnect power. Changing the Light Bulbs IMPORTANT: The lights in both the refrigerator and freezer compartments use LED technology that do not need to be replaced. If the lights do not illuminate when the door or drawer is opened, call for assistance or service. Refer to the Quick Start Guide for contact information. The lighting system in this appliance may consist of: � Sealed LED modules � LED Bulbs � Incandescent Bulbs � or a combination of the above. NOTE: If your product has a sealed LED module, call for assistance or service . Refer to the Quick Start Guide for contact information. IMPORTANT: � Depending on your model, the light bulb in your new refrigerator may use LED technology. If your model uses LED lighting and the light does not illuminate when the refrigerator door is opened, call for assistance or service. � Some LED replacement bulbs are not recommended for wet/ damp environments. The refrigerator and freezer compartments are considered to be wet/dam environments. If using a brand of LED bulb other than the recommended LED bulb listed below, before installation, read and follow all instructions on the LED packaging. � If an incandescent bulb is used to replace an LED bulb, use only incandescent bulbs for household appliances with a maximum of 40 W. 3