Whirlpool WTW7800XW Owners Manual - Page 11
Washer Maintenance - lid
UPC - 883049205168
View all Whirlpool WTW7800XW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
9. Select cycle options Select any other cycle options you may wish to add, if not previously set. Some cycles will automatically add certain options such as Deep Clean or Extra Rinse. These may be turned off, if desired. NOTE: Not all options are available with all cycles. 10. P ress START/PAUSE to begin wash cycle WASHER MAINTENANCE WATER INLET HOSES Replace inlet hoses after 5 years of use to reduce the risk of hose failure. Periodically inspect and replace inlet hoses if bulges, kinks, cuts, wear, or leaks are found. When replacing your inlet hoses, mark the date of replacement on the label with a permanent marker. CLEANING YOUR WASHER Keep your washer as clean and fresh as your clothes. To keep washer interior odor-free, follow this recommended monthly cleaning procedure: 1. Make sure the washer is empty. 2. Using recommended AFFRESH® washer cleaner, add one tablet to washer drum. OR If using liquid chlorine bleach, add 1 cup (250 mL) to liquid chlorine bleach dispenser. Press the START/PAUSE button to start the wash cycle. Filling is delayed for several minutes while load balance is sensed. When the cycle has finished, the DONE indicator will light and the end of cycle signal will sound (if set). Promptly remove garments when cycle is done to avoid odor, reduce wrinkling, and rusting of metal hooks, zippers, and snaps. Unlocking the lid to add garments If you need to open the lid to add 1 or 2 missed garments, you may do so while the Add a Garment indicator is lit. Press START/PAUSE; the lid will unlock once the washer movement has stopped. This may take several minutes if the load was spinning at high speed. Then close lid and press START/PAUSE again to resume the cycle. If lid is left open for more than 10 minutes the water will pump out. Delay in water fill Filling is delayed for 2 to 3 minutes to check for load unbalance. You will hear the hum of the spin prior to filling. This is normal operation. IMPORTANT: Do not add detergent to CLEAN WASHER with AFFRESH™ cycle. Do not use more than recommended amount of bleach to avoid damaging product over time. 3. Close washer lid. 4. Press POWER. 5. Select CLEAN WASHER with AFFRESH™ cycle. 6. Press START/PAUSE. Water will pour into washer for a moment and pause, lid will lock, then cycle will continue. NOTE: For best results, do not interrupt cycle. If cycle must be interrupted, press START/PAUSE twice and run a RINSE AND SPIN cycle to ensure cleaner or bleach have been rinsed from washer. To clean exterior: 1. Use a soft, damp cloth or sponge to wipe up any spills. 2. Use all-purpose surface cleaner, if needed. IMPORTANT: To avoid damaging the washer's finish, do not use abrasive products. 11