Whirlpool WUI75X15H Owners Manual - Page 4

4. Replace the drain cap securely on the water pan. If the drain cap is loose, water will empty from the water pan and you will have either thin ice or no ice. 5. Read and follow all handling information on the cleaner bottle before completing the steps below. Use one 16 oz (473 mL) bottle of approved ice maker cleaner. 6. Pour one bottle of solution into the water pan. Fill the bottle twice with tap water and pour it into the water pan. A B WARNING Electrical Shock Hazard Disconnect power before cleaning. Replace all parts and panels before operating. Failure to do so can result in death or electrical shock. A. Water pan B. Drain cap 7. Press the CLEAN button. See "Using the Controls." The Clean button will blink, indicating that the cleaning cycle is in process. When the "Cleaning Complete" light is illuminated (approximately 70 minutes), the cleaning cycle is complete. During the cleaning cycle, the system will both clean and rinse itself. 8. After the cleaning cycle is complete, remove the drain cap from the water pan. Look for any cleaning solution left in the water pan. If cleaning solution drains from the water pan, you should run the clean cycle again. Be sure to refill the water pan with cleaner before starting the clean cycle again. Be sure to replace the drain cap securely on the water pan. If the drain cap is loose, water will empty from the water pan and you will have either thin ice or no ice. NOTE: Severe scale buildup may require repeated cleaning with a fresh quantity of cleaning solution. 9. Press the ON/OFF button to resume ice production. Condenser A Dirty or Clogged Condenser ■■ Obstructs proper airflow. ■■ Reduces ice making capacity. ■■ Causes higher than recommended operating temperatures which may lead to component failure. 1. Unplug ice maker or disconnect power. 2. Remove the 2 screws in the lower access panel and the 2 screws from the base grille area of the front panel support. 3. Pull the bottom forward and then pull down to remove the lower access panel. 4. Remove dirt and lint from the condenser fins and the unit compartment with a brush attachment on a vacuum cleaner. A A. Condenser fins 5. Replace the lower access panel using the 4 screws. 6. Plug in ice maker or reconnect power. ACCESSORIES To order accessories, in the U.S.A., visit our web site www.whirlpool.com/accessories or call 1-800-901-2042. In Canada, visit our website www.whirlpoolparts.ca or call 1-800-807-6777. Water Filter Affresh® Stainless Steel Wipes Order Part Number F2WC9I1 or ICE2 In U.S.A., order Part Number W10355049 Cleaner In Canada, order Part Number W10355049B Order Part Number 4396808 Affresh® Kitchen & Appliance Cleaner Affresh® Stainless Steel Cleaner In U.S.A., order Part Number W10355010 In U.S.A., order Part Number W10355016 In Canada, order Part Number W10355010B In Canada, order Part Number W10355016B 11-Jun-2018 15:29:29 EDT | RELEASED In some European 4factories the letter "W" of the part code mentioned herein will be automatically replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")