Whirlpool WVW51UC0FS Installation Guide - Page 9

Make Electrical Connection WARNING 6. Use UL listed wire connectors and connect white wires (C) together. WARNING Electrical Shock Hazard Disconnect power before servicing. Replace all parts and panels before operating. Failure to do so can result in death or electrical shock. 1. Disconnect power. 2. Remove terminal box cover. 3. Remove the knockout in the terminal box and install a UL listed or CSA approved 1/2" strain relief. C B A Electrical Shock Hazard Electrically ground blower. Connect ground wire to green and yellow ground wire in terminal box. Failure to do so can result in death or electrical shock. 7. Connect green (or bare) ground wire from home power supply to yellow-green ground wire (F) in terminal box using UL listed wire connectors. 8. Tighten strain relief screw. 9. Install terminal box cover. 10. Check that all light bulbs are secure in their sockets. 11. Reconnect power. Install Vent Covers NOTE: Remove protective film from the vent covers. 1. When using both upper and lower vent covers, push lower cover down onto hood, and then lift upper cover to ceiling and install with (2) 4.2 x 8 mm screws. B A. Terminal box A B. Knockout C. Terminal box cover 4. Run home power supply cable through strain relief into terminal box. A B C FE C D G A. Home power supply cable B. UL listed or CSA approved strain relief C. UL listed wire connectors D. White wires E. Black wires F. Green (or bare) and yellow-green ground wires G. Terminal box 5. Use UL listed wire connectors and connect black wires (E) together. A. Bracket B. 4.2 x 8 mm screws C. Vent cover NOTE: For vented installations the upper vent cover may be reversed to hide slots. 9