Xerox 1235/DX Troubleshooting Guide - Page 100
Phaser 1235 Network Color Printers, Troubleshooting, Message, Explanation/Corrective Action - ram
UPC - 042215474542
View all Xerox 1235/DX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 100 highlights
Troubleshooting Front Panel Messages (cont'd.) Message Engine EPROM Missing U3 Power Off/On Type Fault Engine RAM Error U1 Power Off/On Fault Engine ROM Error U0 Power Off/On Fault Engine SRAM Error U4 Power Off/On Fault Feeder Home Error U7 Power Off/On Fault Front Cover B Open Close Front Cover B Front Panel Error U15 Power Off/On Fault Fault Fuser Lower Error T2 Power Off/On Fault Fuser Missing Reseat Fuser Fault Explanation/Corrective Action During the printer's self diagnostics there was a problem detecting the engine EPROM. Turn off the printer, wait 15 seconds, then turn on the printer. If the problem persists, check the support links at www.xerox.com/officeprinting/1235support. During the printer's self diagnostics there was a problem reading the engine RAM. Turn off the printer, wait 15 seconds, then turn on the printer. If the problem persists, check the support links at www.xerox.com/officeprinting/1235support. During the printer's self diagnostics there was a problem reading the engine ROM. Turn off the printer, wait 15 seconds, then turn on the printer. If the problem persists, check the support links at www.xerox.com/officeprinting/1235support. During the printer's self diagnostics there was a problem reading the engine SRAM. Turn off the printer, wait 15 seconds, then turn on the printer. If the problem persists, check the support links at www.xerox.com/officeprinting/1235support. An error has been detected with the home position of the front paper feeder. Turn off the printer, wait 15 seconds, then turn on the printer. If the problem persists, check the support links at www.xerox.com/officeprinting/1235support. The front cover (Cover B) is open. Close the cover so that printing can continue. An error has been detected with the front panel interface and communication path. Turn off the printer, wait 15 seconds, then turn on the printer. If the problem persists, check the support links at www.xerox.com/officeprinting/1235support. A short fault in the lower fuser Thermistor was discovered. Turn off the printer, wait 15 seconds, then turn on the printer. If the problem persists, install a new fuser. For further assistance, visit the support links at www.xerox.com/officeprinting/1235support. The fuser is either missing or requires reseating to be recognized by the printer. Turn off the printer, make sure the fuser is properly installed and turn on the printer. If the problem persists, install a new fuser. For further assistance, visit the support links at www.xerox.com/officeprinting/1235support. 84 Phaser 1235 Network Color Printers