Xerox 850DP Xerox Wide Format 8850 Operator Manual - Page 52
Status codes, Table 2., Status, code table, Explanation
UPC - 042215454858
View all Xerox 850DP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
PROBLEM SOLVING Status codes The status codes shown in the table below may appear on the message display. Follow the instructions in the table before calling for service. Table 2. Status code table Status code C0.-C1.-C2.-C3.-C4.-- E2.-- E4.-- E5.-E6.-- E7.-- E9.-F1.-- F2.-- J1.01 J2.02 LL.-- Explanation This code indicates a cutter problem. Follow the instructions on the message display. This code indicates a problem with roll 1. Follow the instructions on the message display. This code indicates a problem with roll 2. Follow the instructions on the message display. This code indicates a problem with roll 3. Follow the instructions on the message display. This code indicates a problem at the cut sheet feed-in shelf. Follow the instructions on the message display. This code indicates a problem in the paper path. Follow the instructions on the message display. This code indicates a problem in the fuser area. Follow the instructions on the message display. This code indicates an interlock problem. Follow the instructions on the message display. This code indicates a problem in the paper path. Follow the instructions on the message display. This code indicates a communication failure with the AccXES controller. Switch the printer and controller off. Wait a few seconds. Then switch the controller and printer on. Switch the printer off. Wait a few seconds. Then switch the printer on. This code indicates a problem in the finisher. Follow the instructions on the message display. This code indicates a problem in the finisher. Follow the instructions on the message display. This code indicates that the toner cartridge should be replaced. Refer to the "Replacing the toner cartridge" section of this manual. This code indicates that the toner cartridge is not installed correctly. Refer to the "Replacing the toner cartridge" section of this manual. Switch the printer off. Wait several seconds. Then switch the printer on. 42 XES SYNERGIX 8850 PRINTER OPERATOR MANUAL