Xerox 8860DN User Guide - Page 154
Maintenance Safety, Phaser® 8560/8860 Printer
![]() |
UPC - 095205735246
View all Xerox 8860DN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 154 highlights
If you notice unusual noises or odors: 1. Turn off the printer immediately. 2. Disconnect the power cord from the electrical outlet. 3. Call an authorized service representative to correct the problem. The power cord is attached to the printer as a plug-in device at the back of the printer. If it is necessary to disconnect all electrical power from the printer, disconnect the power cord from the electrical outlet. Warning: Do not remove the covers or guards that are fastened with screws unless you are installing optional equipment and are specifically instructed to do so. Power should be OFF when performing these installations. Disconnect the power cord when removing covers and guards for installing optional equipment. Except for user-installable options, there are no parts that you can maintain or service behind these covers. Note: Leave the printer on for optimum performance; it does not pose a safety hazard. The following are hazards to your safety: ■ The power cord is damaged or frayed. ■ Liquid is spilled into the printer. ■ The printer is exposed to water. If any of these conditions occur, do the following: 1. Turn off the printer immediately. 2. Disconnect the power cord from the electrical outlet. 3. Call an authorized service representative. Maintenance Safety ■ Do not attempt any maintenance procedure that is not specifically described in the documentation supplied with your printer. ■ Do not use aerosol cleaners. The use of supplies that are not approved may cause poor performance and could create a hazardous condition. ■ Do not burn any consumables or routine maintenance items. For information on Xerox supplies recycling programs, go to www.xerox.com/gwa. Phaser® 8560/8860 Printer A-2
![](/manual_guide/products/xerox-8860dn-user-guide-984a216/154.png)