Yamaha 12 GF24/12 GF16/12 GF12/12 Owners Manual - Page 14
TAPE IN Other controls/connectors, ST stereo control, ON switch
View all Yamaha 12 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
14 Front and rear panel s TAPE IN section This section controls the signal that is input from the TAPE IN jacks (page 17, 4 in the connector section). The input signal from the TAPE IN jacks can be sent directly from the ST bus, and can also be monitored from the C-R OUT jacks or PHONES jack. 1 0 10 2 ON TAPE IN 1 ST (stereo) control This adjusts the level at which the input signal from the TAPE IN jacks is output to the ST bus. 2 ON switch This is an on/off switch for the signal that is sent from the TAPE IN jacks to the ST bus. Even when this switch is off, the TAPE IN switch (page 15, 3 in the other controls/connector section) can be turned on to allow monitoring of the TAPE IN input signal from the C-R OUT jacks or the PHONES jack. PHANTOM +48V OFF ON 1 METER SELECT STEREO PFL•AFL GROUP TAPE IN 2 3 0 10 C-R MONITOR LEVEL 0 10 PHONES LEVEL 4 5 PHONES 6 -Owner's Manual s Other controls/connectors 1 PHANTOM +48 V (phantom power supply) switch This is the on/off switch for the +48 V phantom power supply. When this switch is on, the PHANTOM indicator (page 16, 3 in the meter bridge section) will light, and DC +48 V phantom power will be supplied to the INPUT A jacks (page 18, 7 in the connector section) of each mono input channel. Caution: When phantom power is on, connecting an unbalanced device or a device whose transformer is center-grounded may cause hum, noise, or malfunctions. If you do not require phantom power, be sure to turn this switch off. 2 METER SELECT switch This selects the signal source whose level will be shown by the level meters. When the switch is down ( ) The level meters will show the output level of the GROUP buses 1-4. When the switch is up ( ) The two level meters at the left will show the output level of the ST bus, and the two level meters at the right will show the output level of either the PFL/AFL bus or the TAPE IN jacks (page 17, 4 in the connector section), depending on the setting of the TAPE IN switch (3).