Yamaha 400BT STAGEPAS 600BT/STAGEPAS 400BT Owners Manual - Page 12
Connectin, microphones, instruments, and audio, devices to the mixer, Gettin, sound out of the system
View all Yamaha 400BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Quick Start Guide Connecting microphones, instruments, and audio devices to the mixer 4. Connect desired devices, such as a microphone, or an instrument to the input jack of the mixer. Refer to the illustration on the mixer shown below or the connection example of the cover panel of the accessory compartment. Getting sound out of the system 5. Connect the included power cord as described in the steps below: Before connecting the power cord, make sure that the power to the STAGEPAS is turned off. 5-1 Connect the plug on the included power cord to the AC IN jack on the rear panel of the unit. Warning The STAGEPAS has been designed for grounded use. To avoid electrical shock and damage to devices, be sure to ground the unit using the included power cord. If you have any questions regarding connections, contact your nearest Yamaha dealer. Warning Use only the included power cord. Otherwise, heat may be generated or electrical shock may be caused. Notice Even when the power switch is turned off, a minimal amount of electric current is still flowing to the unit. If you plan not to use the unit for an extended period of time, be sure to unplug the power cord from the AC outlet. 6. Turn the mixer's LEVEL controls (white knobs) and MASTER LEVEL control (red knob) to the minimum (zero). Also, set the equalizer controls (green knobs) to the center "%" or "MUSIC" position. Equalizer 5-2 Connect the other end of the power cord to a power outlet. NOTE To disconnect the power cord, reverse these steps. 12 STAGEPAS 600BT/STAGEPAS 400BT Owner's Manual