Yamaha 400BT STAGEPAS 600BT/STAGEPAS 400BT Owners Manual - Page 9

3 Hi-Z switch (channel 4) This switch is used when connecting a device directly to the mixer without a DI (direct box) - for example, instruments with passive pickups, such as an acoustic-electric guitar or electric bass without a battery. This function is effective only for the phone jack input. 4 Line (stereo) input jacks STAGEPAS 600BT (channels 5/6, 7/8, 9/10) STAGEPAS 400BT (channels 5/6, 7/8) Connect line-level devices such as electronic instruments, acoustic-electric guitars, CD players, and portable audio players. These jacks support phone, RCA-pin, and stereo-mini plugs. RCA Pin Stereo Mini NOTE For the channel 7/8 input (STAGEPAS 600BT), or for the channel 5/6 input (STAGEPAS 400BT), if both phone and RCA-pin jacks are used at the same time, the phone jack will take priority. For the channel 9/10 input (STAGEPAS 600BT), or the channel 7/8 (STAGEPAS 400BT), if both phone and stereo mini jacks are used at the same time, the stereo mini jack will take priority. The signal from the device connected to another jack will be muted. The signals from the Bluetooth device specified by the Bluetooth button 9 are always mixed to channels 9/10 (STAGEPAS 600BT) or channels 7/8 (STAGEPAS 400BT). 5 MONITOR OUT jacks These connect to powered speakers for monitoring purposes, and output a mix of the signals from channels 1 to 9/10 (STAGEPAS 600BT) or channels 1 to 7/8 (STAGEPAS 400BT). You can adjust the output level using the MONITOR OUT control A. If only the L (MONO) jack is used, the signals from the L and R channels are mixed and output. 6 SUBWOOFER OUT jack This connects to a powered subwoofer, and outputs a mono signal. If this jack is in use, the low frequencies below 120Hz to the SPEAKERS L/R jacks will be cut. The output level is linked to that of the MASTER LEVEL control L. 7 REVERB FOOT SW jack This connects to an unlatched-type footswitch, such as the Yamaha FC5. This can be useful for solo performers, since you can toggle the reverb on and off as needed with your foot. 8 SPEAKERS L/R jacks Use the included speaker cables to connect the dedicated speakers. Controls and Functions 9 Bluetooth button/LED This button switches the Bluetooth function on or off. It is also used to pair (register) a Bluetooth device (page 15). The Bluetooth LED indicates the following status: LED Off Lit steadily Flashing slowly Flashing fast Status Bluetooth off Bluetooth connected Waiting for Bluetooth connection Pairing a Bluetooth device NOTE The STAGEPAS enables you to pair (register) up to eight Bluetooth devices. Once the ninth Bluetooth device has been paired successfully, the pairing information for the Bluetooth device that was connected earliest will be deleted. 0 PHANTOM (CH1/2) switch /LED When this switch is on, the LED lights up, indicating that phantom power is available for channels 1 and 2. Turn this switch on to supply power to condenser microphones or a DI (direct box). Notice Follow the important precautions below to prevent noise and possible damage to external devices and the unit when you operate this switch. • Be sure to leave this switch off if you do not need phantom power, or when you connect a device that does not support phantom power to channels 1 or 2. • Do not connect/disconnect a cable to/from channels 1 and 2 while this switch is on. • Turn the LEVEL control of the channels 1 and 2 to the minimum before operating this switch. A MONITOR OUT control Determines the signal level output from the MONITOR OUT jacks 5. The MASTER LEVEL control does not affect the MONITOR OUT signal. B Equalizer controls (HIGH, MID*, LOW) *Only for STAGEPAS 600BT This three-band equalizer adjusts the channel's high, mid*, and low frequency bands. Setting the control to the "%" position produces a flat response in the corresponding band. Turning the control clockwise boosts the selected band. If you start getting feedback, turn the control back slightly. C REVERB switch/LED When this switch is on, the LED lights up, indicating that you can apply reverb. This switch is off when you turn on the unit. (Unlike other switches, this switch cannot be locked.) STAGEPAS 600BT/STAGEPAS 400BT Owner's Manual 9 English