Yamaha 6260 Owners Manual - Page 73
Auto Setup (YPAO), Before Auto Setup, During Auto Setup
UPC - 027108933115
View all Yamaha 6260 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
INTRODUCTION PREPARATION BASIC OPERATION Troubleshooting Auto Setup (YPAO) Notes • If the "ERROR" or "WARNING" screen appears, resolve the problem and then run "Auto Setup" again. • Warning message "W-2" or "W-3" indicates that the adjusted settings may not be optimal. • Depending on the speakers, warning message "W-1" may appears even if the speaker connections are correct. • If error message "E-10" occurs repeatedly, contact a qualified Yamaha service center. Before Auto Setup Error message Connect MIC! Unplug HP! Memory Guard! Cause Remedy Optimizer microphone is not connected. Headphones are connected. The parameters of this unit are protected. Connect the supplied optimizer microphone to the OPTIMIZER MIC jack on the front panel. Unplug the headphones. Set "Memory Guard" to "Off." During Auto Setup See page 19 - 56 Error message E-1:NO FRONT SP E-2:NO SUR. SP E-3:NO PRNS SP E-4:SBR->SBL E-5:NOISY E-6:CHECK SUR. E-7:NO MIC E-8:NO SIGNAL Cause Remedy Front L/R channel signals are not detected. Check the front L/R speaker connections. Only a signal from one of the surround channels are detected. Check the surround L/R speaker connections. Only signals from one of the presence L/ Check the presence L/R speaker connections. R channels are detected. Only right surround back channel signal If you connect only one surround back speaker, is detected. connect it to the L-side terminal. Measurement cannot be performed accurately due to loud ambient noise. Try running "Auto Setup" in a quiet environment. Turn off noisy electric equipment like air conditioners or move them away from the optimizer microphone. Surround back speakers are connected, though surround L/R speakers are not. When using surround back speakers, you need to connect surround L/R speakers. The optimizer microphone was unplugged during the "Auto Setup" procedure. Do not touch the optimizer microphone during "Auto Setup." The optimizer microphone does not detect test tones. Check whether the microphone is properly placed. Check whether the speakers are properly placed and connected. The optimizer microphone or OPTIMIZER MIC jack may be defective. Contact the nearest Yamaha dealer or service center. If a monitor such as a TV is connected to this unit via HDMI connection, sound may not be output from this unit due to the HDMI control function. In such a case, change the monitor setting, for example, change the sound output setting to an amplifier so that sound is output from this unit. See page 11 11 11 11 - - 11 19 19 11 19 - ADVANCED OPERATION APPENDIX English 69 En