Yamaha A-S3000 Owners Manual - Page 11

7 8 9 0 AUTO POWER STANDBY ON OFF LINE 1 LINE 2 REC PB ASE INV. NORMAL(EIA) +HOT 2 1 GND 3 - COLD PRE OUT MAIN IN SPEAKERS L CH A OR B:4 MIN./SPEAKER A + B:8 MIN./SPEAKER A SPEAKERS L/R CH terminals B SYSTEM CONNECTOR Use this connector to connect a product testing device for servicing. C REMOTE IN/OUT jacks Use these jacks to connect an external component for remote control. For details on the connection, see page 21. D TRIGGER IN jack Use this jack to connect an external component for the trigger function. For details on the connection, see page 22. E AC IN inlet Use this inlet to plug in the supplied power cable. For details on the connection, see page 19. F Foot The feet of this unit include built-in spikes. Using the spikes can reduce the effect of vibrations on the set. When using the spikes, remove the transport tape, then remove the magnet foot by pulling it. A F 9 PRE OUT jacks y • The PRE OUT jacks output the same channel signal as the SPEAKERS L/R CH terminals. • When you connect a stereo cable to the PRE OUT jacks to drive the speakers using an external amplifier, it is not necessary to use the SPEAKERS L/R CH terminals. • The signal output at the PRE OUT jacks are affected by the BASS and TREBLE control settings. 0 MAIN IN jacks Use these jacks to connect an external component equipped with a volume control. Note When you select MAIN DIRECT as the input source, the volume level is fixed. Adjust the volume level using the volume control on the external amplifier connected to the MAIN IN jacks when you select MAIN DIRECT as the input source. For the connection to the MAIN IN jacks, see pages 16 and 17. Transport tape Spike Magnet foot Caution When using the feet's built-in spikes, the spikes may scratch the shelf or floor on which this unit is installed. Use the magnet feet or appropriate supports when placing this unit on expensive furniture, etc. y If this unit is unstable, you can adjust the foot height by rotating it. English 11 En