Yamaha A-S3000 Owners Manual - Page 22

Connections ■ Connecting a component supporting the trigger function such as a Yamaha AV receiver The operations of this unit can be controlled in synchronization with the operations of the connected component, such as a Yamaha AV receiver (power ON/ STANDBY or MAIN DIRECT input selection). Connect the PRE OUT jacks and the TRIGGER OUT jack of the Yamaha AV receiver to this unit as illustrated below: Rear panel of A-S3000 GND PHONO TUNER CD BAL 1 BAL 2 AUTO POWER STANDBY ON OFF LINE 1 LINE 2 REC SPEAKERS R CH PB ATTENUATOR PHASE BYPASS ATT. NORMAL INV. (-6DB) ATTENUATOR PHASE BYPASS ATT. NORMAL INV. (-6DB) NORMAL(EIA) +HOT 2 1 GND 3 - COLD SYSTEM CONNECTOR REMOTE IN OUT TRIGGER IN AC IN PRE OUT MAIN IN SPEAKERS L CH A OR B:4 MIN./SPEAKER A + B:8 MIN./SPEAKER TRIGGER IN A OR B:4 MIN./SPEAKER A + B:8 MIN./SPEAKER MAIN IN RCA stereo cable TRIGGER OUT PRE OUT Yamaha AV receiver, etc. with PRE OUT and TRIGGER OUT jacks When the power of the connected component is turned on, this unit turns on and the input is set to MAIN DIRECT automatically. When MAIN DIRECT is selected as the input source, this unit enters STANDBY mode if the power of the connected component is turned off. Note To enable synchronization, turn off this unit before connecting the component to the MAIN IN jacks. The synchronization cannot be activated when the STANDBY/ON/OFF switch of the unit has been set to OFF. 22 En