Yamaha CDC-775 Owner's Manual - Page 25

English NOTES ABOUT THE REMOTE CONTROL TRANSMITTER Battery installation Remote control transmitter operation range 2 1 3 Battery replacement If you find that the remote control transmitter must be used closer to the main unit, the batteries are weak. Replace both batteries with new ones. Notes q Use only AA, R6, UM-3 batteries for replacement. q Be sure the polarities are correct. (See the illustration inside the battery compartment.) q Remove the batteries if the remote control transmitter will not be used for an extended period of time. q If batteries leak, dispose of them immediately. Avoid touching the leaked material or letting it come in contact with clothing, etc. Clean the battery compartment thoroughly before installing new batteries. Remote control sensor Within approximately 6 m (19.7 feet) 30° 30° Notes q There should be no large obstacles between the remote control transmitter and the main unit. q If the remote control sensor is directly illuminated by strong lighting (especially an inverter type of fluorescent lamp, etc.), it might cause the remote control transmitter not to work correctly. In this case, reposition the main unit to avoid direct lighting. TIMER PLAY You can start play at any specified time by connecting a timer (sold separately). Refer also to the instructions for the timer. 1. Select the desired play mode (1DISC or 5DISCS). 2. Press the POWER switch to turn the unit off. 3. Press the POWER switch while pressing the PLAY/PAUSE ( ) button on the front panel. Shortly thereafter, "TIMER P. ON" appears in the display and the timer play function is on. (When the timer play function is already on, in which case, "TIMER P. OFF" appears in the display and timer play function is off. In this case, repeat the procedure in steps 2 and 3 to set the timer play function to on.) 4. Set the timer to the desired time. When the set time comes, the unit turns on and starts play. 25