Yamaha CDX-E100RDS Owner's Manual - Page 29
Additional Information, English
View all Yamaha CDX-E100RDS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
English RX-E100 RECEIVER ADDITIONAL INFORMATION SYMPTOM Excessive static in FM broadcasts. Noise increases during stereo broadcasts. Stereo broadcasts are noisy and STEREO indicator blinks on and off. Cannot select preset stations. Buzzing or static during AM broadcasts. AM broadcast sensitivity is poor. Cannot set timer. The unit does not work normally. Play does not begin. Play is delayed, or begins at the wrong place. CD synchronized recording or Automatic recording function does not work. Sound "skips." Sound "hums." Noise from inside of the unit. The remote control does not work. TV functions strangely when the remote control is being used. CAUSE REMEDY Interference from starting motor of a nearby car. Interference from the thermostat of a nearby electrical appliance. Position the FM antenna as high and as far away from nearby roads as possible. Connect using a coaxial cable. Antenna input is too weak due to obstructions or excessive distance from the broadcasting station. Check the antenna connection. Install a multi-element type FM antenna if possible. Insufficient antenna input. Install an antenna appropriate for the electric field strength of your area. Preset memory has been erased. Reprogram memory presets. Interference from sources such as lightning, fluorescent lights, electric motors or thermostat of nearby electrical appliance. The problem is difficult to eliminate, but can be lessened by grounding AM loop antenna. TV or microprocessor is being used nearby. Move away from TV or microprocessor. Radio signal is weak or the antenna is not properly connected. Properly connect the AM loop antenna. Change orientation of the AM loop antenna. Install an external AM loop antenna. Current time is not set. Set current time. The internal microcomputer has been frozen by an external electric shock (lightning, excessive static electricity, etc.) or the power supply with low voltage. Unplug the AC power cord from the wall outlet, and then plug in again after about one minute. The disc is damaged. Check the disc carefully; replace it if necessary. There is moisture on the laser pick-up. Wait 20 to 30 minutes after switching the unit ON before trying to play a disc. The disc has been loaded upside down. Reload the disc with the label side facing up. The disc is dirty. Clean the disc. The disc may be scratched or damaged. Check the disc carefully; replace it if necessary. The system cable is not connected securely. Connect the system cable properly. The unit is being subjected to vibrations or impacts. The disc is dirty. Improper cable connections. The disc may be warped. The batteries of the remote control are too weak. Remote control is too far away or is being used at an incorrect angle. Direct sunlight or lighting (of an inverter type of fluorescent lamp, etc.) is striking the remote control sensor of the unit. Remote control is being used near TV set with a remote control sensor. Relocate the unit. Clean the disc. Securely connect the audio cables. If the problem persists, the cables may be defective. Replace the disc. Replace the batteries with new ones. Use within 6 meters and 60 degree radius. Change the position of the unit. Relocate this unit away from the TV or cover the TV's remote control sensor. CDX-E100 CD PLAYER REMOTE CONTROL E-27