Yamaha CRX-E500 Owner's Manual - Page 14
BASIC OPERATIONS, Listening to a source, When you use headphones, When you have finished using
View all Yamaha CRX-E500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
BASIC OPERATIONS Listening to a source STANDBY/ON TREBLE VOLUME STANDBY/ON TIMER PHONES NATURAL SOUND STEREO RECEIVER RX-E400 VOLUME DISPLAY MEMORY AUTO/MAN'L PRESET/BAND TIMER ADJ BASS TIMER TREBLE PRESET/TUNING HOUR MIN BALANCE - + - + L R MIN MAX INPUT PHONES BASS BALANCE INPUT POWER 1 2 3 1 2 3 4 5 6 4 5 6 7 8 9 7 8 0 +10 +100 REP RANDOM PROG A B C MODE TEXT/TIME DISC SKIP D E POWER TAPE DIRECTION PRESET TUNER PRESET MD CD TAPE AUX MD REC/PAUSE TAPE REC/PAUSE MODE DUBBING START SLEEP DISPLAY VOLUME VOLUME %/fi 10 1 Set the volume to "MIN" by turning VOLUME. 2 Turn on the power by pressing STANDBY/ON on the front panel, or POWER on the remote control. • Piano Craft series components that have correct system connections made to RX-E400 can be controlled to turn to the on or standby mode by RX-E400. However, once the connected components are turned to the standby mode with their respective STANDBY/ON, they cannot be controlled by RX-E400 STANDBY/ON. 3 Select the desired input source by turning INPUT so that the source appears on the display. • When you operate the component connected to the AUX terminal, turn INPUT to select AUX. 4 Play the source. (Refer to the owner's manual supplied with each selected component.) 5 Adjust the volume level by turning VOLUME on the front panel or pressing VOLUME %/fi on the remote control. 6 If desired, adjust BASS, TREBLE, and BALANCE. BASS: Turn this control clockwise to increase (or counterclockwise to decrease) the low frequency response. TREBLE: Turn this control clockwise to increase (or counterclockwise to decrease) the high frequency response. BALANCE: Adjust the balance of the output volume from the left and right speakers to compensate for sound imbalance caused by the speaker location or listening room conditions. When you use headphones Connect the headphones to the PHONES jack. You can listen to the sound to be output from the main speakers through the headphones. When you have finished using this unit Press STANDBY/ON on the front panel again or POWER on the remote control to set this unit to the standby mode. Auto standby function This unit will be put automatically into the standby mode under the following conditions: • A component connected with a system control cable is selected as an input source. • The component connected to this unit is in stop mode and not operated for 30 minutes.