Yamaha CRX-E500 Owner's Manual - Page 29

CDC-E500 CD PLAYER ADDITIONAL INFORMATION SYMPTOM Play does not begin. Play is delayed, or begins at the wrong place. CD synchronized recording or Automatic recording function does not work. Sound "skips." Sound "hums." Noise from inside of the unit. The remote control does not work. TV functions strangely when the remote control is being used. CAUSE The disc is damaged. There is moisture on the laser pick-up. The disc has been loaded upside down. The disc is dirty. The disc may be scratched or damaged. REMEDY Check the disc carefully; replace it if necessary. Wait 20 to 30 minutes after switching the unit ON before trying to play a disc. Reload the disc with the label side facing up. Clean the disc. Check the disc carefully; replace it if necessary. The system cable is not connected securely. Connect the system cable properly. The unit is being subjected to vibrations or impacts. The disc is dirty. Improper cable connections. The disc may be warped. The batteries of the remote control are too weak. Remote control is too far away or is being used at an incorrect angle. Direct sunlight or lighting (of an inverter type of fluorescent lamp, etc.) is striking the remote control sensor of the unit. Remote control is being used near TV set with a remote control sensor. Relocate the unit. Clean the disc. Securely connect the audio cables. If the problem persists, the cables may be defective. Replace the disc. Replace the batteries with new ones. Use within 6 meters and 60 degree radius. Change the position of the unit. Relocate this unit away from the TV or cover the TV's remote control sensor. REMOTE CONTROL 25