Yamaha DSP-E200 Owner's Manual - Page 11

ADJUSTMENT BEFORE OPERATION SPEAKER BALANCE ADJUSTMENT Using the built-in test tone generator, this procedure lets you adjust the sound output level balance between the front, center, and rear speakers. With this adjustment, the sound output level heard at the listening position will be the same from each speaker. This is important for the best performance of digital sound field processor. The adjustment of each speaker output level should be done at your listening position with the remote control transmitter. Otherwise, the result may not be satisfactory. 2 31 54 1 VOLUME 0 - dB ∞ Set to the " " position. 2 Set on the POWER of this unit and the amplifier etc. POWER 3 DIGITAL SOUND FIELD PROCESSING CONCERT MONO ROCK CONCERT PRO LOGIC ENHANCED VIDEO MOVIE CONCERT HALL OFF DOLBY SUR. 4 Select the center mode depending on your speaker configuration. (Refer to "SPEAKER CONFIGURATION" on page 5.) NORMAL WIDE PHANTOM CENTER MODE On the feature of each mode, refer to the "Note" shown below. 5 TEST DELAY TEST ms NORMAL FCR PRO LOGIC CONCERT MONO ROCK CONCERT ENHANCED VIDEO MOVIE CONCERT HALL Flashes on and off continuously. Note In step 4, when you select the center mode, note the following. For 5 speaker configuration) NORMAL: Select this mode when you use the center speaker smaller sized than the front speakers. In this mode, the bass tone will be output from the front speakers. WIDE: Select this mode when you use the center speaker approximately same sized as the front speakers. For 4 speaker configuration) PHANTOM: Select this mode when you do not use the center speaker. The center sound will be output from the left and the right front speakers. 11