Yamaha DSP-E200 Owner's Manual - Page 9

Connecting Speakers, About The Accessory Terminals, Ac Outlet Unswitched, Center Out Terminal - amplifier

Get Yamaha DSP-E200 PDF manuals and user guides View all Yamaha DSP-E200 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 9 highlights

CONNECTING SPEAKERS Connect the SPEAKERS terminals to your speakers with wire of the proper gauge, cut to be as short as possible. If the connections are faulty, no sound will be heard from the speakers. Make sure that the polarity of the speaker wires is correct, that is, + and - markings are observed. If these wires are reversed, the sound will be unnatural and will lack bass. Do not let the bare speaker wires touch each other and do not let them touch the metal parts of this unit as this could damage this unit and/or speakers. * Use speakers with the specified impedance shown on the rear of this unit. How to Connect: Red: positive (+) Black: negative (-) Œ Press and hold the tab.  Insert the bare wire. [Remove approx. 5mm (1/4") insulation from the speaker wires.] Ž Release the tab and secure the wire. ABOUT THE ACCESSORY TERMINALS AC OUTLET (UNSWITCHED) This unswitched AC outlet can be used for connection of the power cord from another audio component. Note that the power to that component is not affected by the ON or OFF setting of the POWER switch of this unit. Note: The maximum power (total power consumption of components) that can be connected here is 200 watts. CENTER OUT terminal This terminal is for center-channel line output. There is no connection to this terminal when you use the built-in amplifier. However, if you drive a center speaker with an external power amplifier, connect input terminal of the external amplifier to this terminal. If you use the built-in amplifier and the external power amplifier at the same time, the sound will be output through both speakers. 9

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
9
Connect the
SPEAKERS
terminals to your speakers with wire
of the proper gauge, cut to be as short as possible.
If the
connections are faulty, no sound will be heard from the
speakers.
Make sure that the polarity of the speaker wires is
correct, that is, + and – markings are observed.
If these wires
are reversed, the sound will be unnatural and will lack bass.
Do not let the bare speaker wires touch each other and do
not let them touch the metal parts of this unit as this could
damage this unit and/or speakers.
*
Use speakers with the specified impedance shown on the
rear of this unit.
How to Connect:
Red: positive (+)
Black: negative (–)
Press and hold the tab.
Insert the bare wire.
[Remove approx. 5mm
(1/4”) insulation from
the speaker wires.]
Release the tab and
secure the wire.
CONNECTING SPEAKERS
ABOUT THE ACCESSORY TERMINALS
AC OUTLET (UNSWITCHED)
This unswitched AC outlet can be used for connection of the
power cord from another audio component.
Note that the
power to that component is not affected by the ON or OFF
setting of the
POWER
switch of this unit.
Note:
The maximum power (total power consumption of
components) that can be connected here is 200 watts.
CENTER OUT terminal
This terminal is for center-channel line output.
There is no
connection to this terminal when you use the built-in amplifier.
However, if you drive a center speaker with an external power
amplifier, connect input terminal of the external amplifier to this
terminal.
If you use the built-in amplifier and the external power amplifier
at the same time, the sound will be output through both
speakers.