Yamaha DSP-E390 Owner's Manual - Page 13

2 1 To play a source with the digital sound field processor 6 3 1, 7 6 TAPE MONITOR PROGRAM PRO LOGIC - ENHANCED CNCT VIDEO MONO MOVIE SUR. ROCK HALL EFFECT ON/OFF TEST CENTER MODE 3 5 85 8 DELAY TIME + - MASTER VOLUME + - 7 4 Play the source. 5 Turn the DSP on, so that a DSP program name appears on the display. ∞ Set to the " " position. 2 Turn the power on. POWER EFFECT CONCERT HALL 6 Select a desired program suitable for the source. 3 Select a source using the input selector on the integrated amplifier etc. * To select a tape deck connected to this unit's TAPE terminals, press the TAPE MONITOR switch so that "TAPE MONITOR" lights up on the display. (Otherwise, press this switch to turn it off.) TAPE MONITOR TAPE MONITOR Note If this unit is connected to the TAPE REC OUT terminals of the integrated amplifier etc., the following operations are needed. • If your amplifier has the REC OUT selector which is independent of the input selector; 1. Set the input selector to the position (AUX, TAPE, etc.) which corresponds to the amplifier's terminals connected to this unit's FRONT OUT terminals. 2. Select the source to be input to this unit using the REC OUT selector. • If your amplifier does not have the REC OUT selector which is independent of the input selector; 1. Set the TAPE monitor switch on the amplifier to on. 2. Select the source to be input to this unit using the input selector. PROGRAM PRO LOGIC The corresponding indicator will light up. 7 Adjust to the desired output level. 8 If desired, adjust the delay time and the output level of each speaker. (For details, refer to the corresponding descriptions on page 14 and 15.) 13