Yamaha DSP-E390 Owner's Manual - Page 15

Adjustment of DELAY TIME You can adjust the time difference between the beginning of the source sound and the beginning of the effect sound with the DELAY TIME keys. The DELAY TIME keys are effective with all programs. By applying more or less delay, sound effects, background noise, and ambient noise coming at you from the rear speakers can be enhanced or subdued for extra effect. 1. PRO LOGIC : from 15 to 30 milliseconds (Preset value: 20 milliseconds) 2. PRO LOGIC : from 15 to 30 milliseconds ENHANCED (Preset value: 20 milliseconds) 3. CONCERT VIDEO : from 1 to 100 milliseconds (Preset value: 25 milliseconds) 4. MONO MOVIE : from 1 to 100 milliseconds (Preset value: 25 milliseconds) 5. ROCK CONCERT : from 1 to 100 milliseconds (Preset value: 15 milliseconds) 6. CONCERT HALL : from 1 to 100 milliseconds (Preset value: 30 milliseconds) q By continuously pressing "+" or "-" key, the value changes continuously. However, the value stops changing momentarily at the preset point. Adjustable DELAY TIME + - DELAY NORMAL WIDE PHANTOM ms TEST Notes q Adding too much delay will cause an unnatural effect with some sources. Experiment with the DELAY TIME keys to create the effect that you find most suitable. q The values of the DELAY TIME you set the last time will remain memorized even when the power of this unit is off. However, if the power cord is kept disconnected for more than one week, these values will be automatically changed back to the original factory settings. NOTES ABOUT THE REMOTE CONTROL TRANSMITTER Battery installation Remote control transmitter operation range 2 1 3 Remote control sensor Within approximately 6 m (19.7 feet) 30° 30° Battery replacement If you find that the remote control transmitter must be used closer to the main unit, the batteries are weak. Replace both batteries with new ones. Notes q Use only AA, R6, UM-3 batteries for replacement. q Be sure the polarities are correct. (See the illustration inside the battery compartment.) q Remove the batteries if the remote control transmitter will not be used for an extended period of time. q If batteries leak, dispose of them immediately. Avoid touching the leaked material or letting it come in contact with clothing, etc. Clean the battery compartment thoroughly before installing new batteries. Notes q There should be no large obstacles between the remote control transmitter and the main unit. q If the remote control sensor is directly illuminated by strong lighting (especially an inverter type of fluorescent lamp etc.), it might cause the remote control transmitter not to work correctly. In this case, reposition the main unit to avoid direct lighting. 15