Yamaha EMX660 Owner's Manual - Page 5
Digital Effect Monitor Effect Rtn Control - used
View all Yamaha EMX660 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Control panel 5 s DIGITAL EFFECT section This section allows you to turn the built-in digital effect on/off and to select the effect type. VO. ECHO 1 VO. ECHO 2 VO. REV. 1 VO. REV. 2 HALL. 1 HALL. 2 ROOM PLATE ON 6 7 DIGITAL EFFECT 6 Effect select switch and indicator Select the effect type for the built-in digital effect. The indicator of the selected effect type lights up. 7 DIGITAL EFFECT ON switch and indicator When this switch is on (pressed), the indicator lights up and the built-in digital effect can be used. In that case, the signal processed by the digital effect will be sent to the MAIN/MONITOR bus. The mix level of the effect sound is adjusted by the EFFECT RTN control of the MAIN and MONITOR sections. s MONITOR section This section allows you to adjust the tone and volume of the MONITOR bus, and specify the mix level of the built-in effect and the external input signals. 8 +12 +12 +6 • 6 • 6 +3 • • 0 0 0 • • 6 6 -5 • • -12 -12 -10 125 250 500 1k 2k 4k 8k B 9 0 10 EFFECT RTN 0 0 10 TAPE IN MONITOR A 0 10 MASTER 8 Graphic equalizer This is a 7-band graphic equalizer that allows you to adjust the frequency response of the MONITOR bus signal, providing a maximum of ±12 dB of cut/boost for each frequency band. You can use these sliders to reduce the level of frequency bands at which feedback easily occurs. Frequency response is flat when a slider is in the center position. Moving a slider in the positive direction will boost, and in the negative direction will cut. This graphic equalizer affects both the MONITOR bus signal that is output to the speakers and the line level signal which is output from the MONITOR jack (input/output panel 6). 9 EFFECT RTN control This controls the level of the effect sound which is returned from the built-in digital effect to the MONITOR bus. 0 TAPE IN control This controls the level of the signal routed from the TAPE IN jack to the MONITOR bus. A MASTER control This adjusts the final level of the MONITOR bus. It affects both the MONITOR bus signal which is output to the speakers and the line level signal which is output to the MONITOR jack (input/ output panel 6). B Peak level indicator This indicator allows you to monitor the level of the signal which is output from the MONITOR jack (input/output panel 6). Note: To avoid distortion, adjust the MASTER control (A) so that the 0 indicator lights occasionally. EMX660-Owner's Manual