Yamaha HTR 5790 MCXSP10 Manual - Page 26
Connecting the power supply cord, Connecting the AC power cord, U.S.A. and Canada models, Other models
UPC - 027108919744
View all Yamaha HTR 5790 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
CONNECTIONS Connecting the power supply cord AC OUTLETS (U.S.A. model) VOLTAGE SELECTOR VOLTAGE SELECTOR 2 ■ Connecting the AC power cord (U.S.A. and Canada models) Plug the power cord into the AC inlet after all other connections are complete, then plug the power cord to an AC wall outlet. CAUTION Do not use other AC power cords. Use the one provided. Use of other power cords may result in fire hazard or electrical shock. (Other models) Plug the power cord into an AC wall outlet. ■ AC OUTLET(S) (SWITCHED) U.K. and Australia models 1 OUTLET Korea model None Other models 2 OUTLETS Use these outlets to connect the power cords from your other components to this unit. Power to the AC OUTLET(S) is controlled by this unit's STANDBY/ON (or SYSTEM POWER and STANDBY). These outlets will supply power to any connected component whenever this unit is turned on. The maximum power (total power consumption of components) that can be connected to the AC OUTLET(S) is: Asia and General models 50 W Korea model N/A Other models 100 W ■ VOLTAGE SELECTOR (Asia and General models only) The VOLTAGE SELECTOR on the rear panel of this unit must be set for your local main voltage BEFORE plugging into the AC main supply. Voltages are 110/120/220/230240 V AC, 50/60 Hz. ■ Memory back-up The memory back-up circuit prevents the stored data from being lost even if this unit is in the standby mode. However if the power cord is disconnected from the AC wall outlet, or the power supply is cut for more than one week, the stored data will be lost. (Asia and General models) 22