Yamaha HTR 5790 MCXSP10 Manual - Page 65
Programming codes from other remote controls
UPC - 027108919744
View all Yamaha HTR 5790 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
REMOTE CONTROL FEATURES 5 Press LEARN again to exit from the setup mode. LEARN 2 Place this remote control about 5 to 10 cm apart from the other remote control on a flat surface so that their infrared transmitters are aimed at each other. TRANSMIT SYSTEM POWER PHONO TUNER V-AUX CBL/SAT MD/TAPE DTV POWER TV Notes • The supplied remote control does not contain all possible manufacturer codes for commercially available AV components (including YAMAHA AV components). If operation is not possible with any of the manufacturer codes, program the new remote control function with the Learn feature (see below) or use the remote control supplied with the component. • If you have already programmed a remote control function for a button, the function by learning programming takes priority over the setup manufacturer code's function. • "ERROR" appears in the display window when press any buttons other than indicated in each step, or when you press more than one button at once. Programming codes from other remote controls If you want to program functions not included in the basic operations covered by the manufacturer code, or an appropriate manufacturer code is not available, do the following. You can program any of the buttons available in the component control area (see page 59). The buttons can be programmed independently for each component. Note This remote control transmits infrared rays. If the other remote control also uses infrared rays, this remote control can learn most of its functions. However, you may not be able to program some special signals or extremely long transmissions. (Refer to the operation instructions for the other remote control.) POWER AV AMP SELECT VCR 1 DVR/VCR2 DVD CD-R MULTI CH IN CD SLEEP INPUT MODE STANDBY RE-NAME CLEAR LEARN 5 to 10 cm (2 to 4 inches) 3 Press LEARN using a ballpoint pen or similar object. Do not press and hold LEARN. If you hold it down for more than three seconds, the remote enters the manufacturer code setting mode. LEARN Flashes alternately y Complete each of the following steps in 30 seconds. Otherwise, the learning mode will be automatically canceled. In this case, press LEARN again. 4 Press the button at which you want to program the new function. "LEARN" is displayed. TRANSMIT SYSTEM POWER PHONO TUNER STANDBY V-AUX CBL/SAT MD/TAPE DTV POWER TV REC DISC SKIP RE-NAME CLEAR LEARN SLEEP INPUT MODE CD VCR 1 DVR/VCR2 DVD POWER AV AUDIO 1 Press an input selector button to select a source component. PHONO TUNER CD MULTI CH IN V-AUX CBL/SAT MD/TAPE CD-R DTV VCR 1 DVR/VCR2 DVD MULTI CH IN CD-R SELECT AMP + VOL - ADVANCED OPERATION 61