Yamaha HTR 6080 MCXSP10 Manual - Page 102
XM Satellite Radio, Remote control, Status message, Cause, Remedy, Problem
View all Yamaha HTR 6080 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 102 highlights
Troubleshooting ■ XM Satellite Radio If an operation takes longer than usual or an error occurs, one of the following messages may appear in the front panel display. In this case, read the cause and follow the corresponding remedies. Status message Cause Remedy CHECK ANTENNA UPDATING NO SIGNAL LOADING OFF AIR - - - The XM Mini-Tuner and XM Dock are not connected to the XM jack of this unit or do not work properly. Check XM Mini-Tuner and XM Dock connections and orient for the best reception level. The XM user encryption code is being updated. Wait until the encryption code is updated. The signal is too weak. Adjust the orientation of the XM Mini-Tuner for the best reception level. It takes longer than four seconds for audio Wait until the decoding process has finished. or text data to be decoded. The XM Satellite Radio channel you selected is not currently broadcasting any signals. Check the channel number again or select another XM Satellite Radio channel. The Channel Station ID (SID) is no longer available. No artist name or song title is available. No channels are available for the selected category. Select another channel category by pressing 4CATEGORY on the front panel (or DA-E/CAT. l / h on the remote control) repeatedly. ■ Remote control Problem The remote control does not work or function properly. Cause Remedy Wrong distance or angle. The remote control will function within a maximum range of 6 m (20 ft) and no more than 30 degrees offaxis from the front panel. Direct sunlight or lighting (from an inverter type of fluorescent lamp, etc.) is striking the remote control sensor of this unit. Reposition this unit. The batteries are weak. Replace all batteries. The operation mode selector is set incorrectly. Set the operation mode selector correctly. When operating this unit, set it to the KAMP position. When operating the component selected by the input selector button, set it to the KSOURCE position. When operating the TV set in the DTV or PHONO area, set it to the KTV position. The remote control code was not correctly Set the remote control code correctly using "List of set. remote control codes" at the end of this manual. Try setting another code of the same manufacturer using "List of remote control codes" at the end of this manual. The ID code of the remote control and the remote control ID of this unit do not match. Match the remote control ID of this unit with the corresponding remote control ID code. See page 53 - 53 - - 55 See page 27 - - - 88 88 91 98 En