Yamaha MG10 Owner's Manual - Page 18
Master Control PHANTOM +48 V Switch, RETURN Control, 2TR IN Control, ST Master Fader - power supply
View all Yamaha MG10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Front & Rear Panels Master Control Section 7 1 2 6 3 5 4 2 RETURN Control Adjusts the level of the signal sent from the RETURN jacks (L (MONO) and R) to the Stereo bus. NOTE If you supply a signal to the RETURN L (MONO) jack only, the mixer outputs the identical signal to both the L and R Stereo buses. 3 2TR IN Control Adjusts the level of the signal sent from the 2TR IN jack to the Stereo bus. 4 ST Master Fader Adjusts the signal level to the ST OUT jacks. 5 C-R/PHONES Control Controls the level of the signal output to the PHONES jack and the C-R L and R jacks. 6 Level Meter This LED display shows the level of the signal fed to the Stereo bus. The "0" point corresponds to the standard output level. The indicator lights up red when the output hits the clipping level. 7 POWER Indicator This indicator lights up when the mixer's power is ON. 1 PHANTOM +48 V Switch This switch toggles phantom power on and off. If you set the switch on, the mixer supplies power to all channels that provide XLR mic input jacks (CHs 1, 2, 3/4, 5/6). Set this switch on ( ) when using one or more condenser microphones. NOTE When this switch is on, the mixer supplies DC +48 V power to pins 2 and 3 of all XLR-type MIC INPUT jacks. • Be sure to leave this switch off ( ) when you are not using phantom power. Humming or damage may result if you connect to an unbalanced device or to an ungrounded transformer while this switch is on ( ). But note that the switch may be left on ( ) without problem when connecting to balanced dynamic microphones. • To avoid damage to speakers, be sure to turn off amplifiers (or powered speakers) before turning this switch on or off. 18 MG10/2