Yamaha MG12XU Owner's Manual - Page 24
Master Block, SEND] jacks, GROUP OUT] jacks, MONITOR OUT] jacks - multitrack recording
View all Yamaha MG12XU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Controls and Connectors Master Block q e r q [SEND] jacks MG20XU/MG20/MG16XU/MG16: [AUX1 - 4] MG12XU/MG12: [AUX1 - 2] w u t You use these jacks, for example, to connect to an external effect device or a stage/studio monitoring system. These are impedance-balanced* phone-type output jacks. * Impedance-balanced Since the hot and cold terminals of impedance-balanced output jacks have the same impedance, these output jacks are less affected by induced noise. w [GROUP OUT] jacks y These impedance-balanced TRS phone jacks output the [GROUP 1-2 and 3-4] (MG20XU/MG20/MG16XU/MG16) signals. Use these jacks to connect to the inputs of a multitrack recorder, external mixer, or another similar device. e [MONITOR OUT] jacks MG16XU i MG20XU Rear Panel Connect these impedance-balanced TRS phone jacks to your operator monitoring system. NOTE When the [PFL] indicator is flashing, the signal for channels where the [PFL] switch is pressed is output. When the [PFL] indicator is off, the signal for the buses selected in the [MONITOR] section y is output. o r e w q 24 MG20XU/MG20/MG16XU/MG16/MG12XU/MG12 Owner's Manual