Yamaha MM1402 Owner's Manual - Page 9

s Master control section K G F E L PHANTOM 00 -20 -15 -10 -6 -3 0 +2 +4 +6 R PFL STEREO GRAPHIC EQUALIZER +12 +12 9 9 6 6 3 3 0 0 3 3 6 6 9 9 -12 -12 100 400 1k 5k 10k MIXER J I H 0 10 AUX SEND 1 0 10 AUX SEND 2 0 10 AUX RETURN 1 0 10 AUX RETURN 2 STEREO L R 0 10 TAPE IN TO MONI 10 0 10 MONITOR 5 0 5 10 0 10 15 PHONES 20 30 00 L M N O P E ST L, R master control These faders adjust the final level of all channels, and output the combined signal to the ST OUT jacks. The OUTPUT LEVEL L, R meters allow you to monitor the L and R outputs. F AUX RETURN 1-2 controls The knobs control the input levels from the effect units etc. connected to AUX RETURN. Since the signals input at AUX RETURN pass through this control and are then output from the ST OUT jacks, AUX RETURN can be used not only to input the signals from effect units but also as supplementary inputs. HA L/MONO AUX RETURN 1,2 -10dB HA R AUX RETURN 1,2 G AUX SEND 1, 2 controls These knobs adjust the level of the signals that are output to AUX SEND 1 and 2. H Graphic equalizer (5 band) Since this equalizer is placed before ST OUT, it allows you to make fine adjustments in equalization to the overall output, for sound field compensation or to prevent feedback. I PFL indicator This indicator will light when a PFL switch is turned ON. J PHANTOM indicator This indicator will light when the PHANTOM switch is ON. K OUTPUT LEVEL L, R meters These meters indicate the output level to the ST OUT jacks. L TAPE input control This knob controls the input signal of the tape deck etc. that is connected to the TAPE IN jacks. M TAPE INPUT select switch This switch selects the destination of the input signal of the tape deck etc. that is connected to the TAPE IN jacks. OFF: sent to the stereo bus ON: sent to MONI OUT (L, R) N MONITOR control This knob adjusts the output level from the MONI OUT jacks. O PHONES control This knob adjusts the volume of the headphones connected to the headphone jack. 4