Yamaha MTX3 MTX3 Owners Manual - Page 15

Quick Guide 8. Make DCP settings. Assign the parameters of the MTX3 to the switches and knobs of the connected DCP units. Here you can also specify the brightness of the DCP's LEDs. For details on how to make DCP settings, refer to "MTX-MRX Editor User Guide." 9. As necessary, make settings for devices other than the MTX3. For details, refer to "MTX Setup Manual." 10. Specify and store a preset. You can use presets to change the volume of zones and the audio source to play (e.g., SD memory card or CD player) in a single action. To prevent problems such as a sudden increase in volume when the MTX3 is operated, we recommend that you store the preset with the output level lowered to "-infinity ()." For details on presets and how to recall them, refer to "Recalling (switching) presets" on page 17, and "MTX-MRX Editor User Guide." 11. Save your settings and close MTX-MRX Editor. A project file with the extension ".mtx" will be created. On-site work (Installation and wiring) Install and connect the system while referring to the schematic diagram you printed out. 1. Install the MTX3, and make the analog audio connections. 2. Make digital connections between the MTX3 and any XMV/EXi8/EXo8. Make a ring connection with the devices equipped with a [YDIF] connector. 3. Connect the MTX3 to an analog input amp. 4. Set the UNIT ID of the MTX3 and the XMV/ EXi8/EXo8. Set the UNIT ID for every MTX3 and XMV/EXi8/EXo8 device you connected in the above steps. The UNIT ID is specified by the combination of the [UNIT ID] rotary switch and DIP switches located on each device's rear panel. Set each device to a different UNIT ID so that no conflict occurs. 5. Make connections between the MTX3 and the DCP units. Daisy-chain the DCP units. Set the panel ID and termination settings of the DCP units. For details, refer to the DCP owner's manual. MTX3 Owner's Manual 15