Yamaha MV800 Owner's Manual - Page 7
Attaching the Security Cover, ST/MONO Select Switch - case
View all Yamaha MV800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Front & Rear Panels 5 • PAGING LEVEL Control Controls the output level of the PAGING MIC/LINE input and adjusts the volume. i PAGING INPUT DUCKER • PAGING TH Control Sets the level at which the mixer switches to its PAGING function. Rotating the knob to the right lowers the level at which the mixer will switch to the paging function. • PAGING Indicator The indicator lights when the paging function is in use. • PAGING ZONE Select Switch Selects the zone to which the PAGING MIC/LINE signal will be sent. The PAGING MIC/LINE signal is sent to the zone output jacks (ZONE 1, 2) that are switched ON. o LEVEL Meter This LED indicates the level of the output signal for each of the ZONE output jacks (ZONE 1,2). "0" indicates a nominal level, and the PEAK indicator will light red to warn when clipping is imminent. !0 ZONE Volume Controls the volume level of the signal that is sent to the ZONE output jacks (ZONE 1, 2). !1 ST/MONO Select Switch Set the switch to ST when the signal from the ST Input jack is to be sent to the ZONE output jacks (ZONE 1, 2) as a stereo signal. Set the switch to MONO when the L and R channels are to be mixed as a monaural signal. !2 ZONE 1 TO 2 Switches Set the switch to its ON (>) position to send the signal from ZONE 1 (pre-volume) to ZONE 2 (pre-volume). In this case, the ZONE 1 (pre-volume) signal will be sent to the ZONE 2 output jacks and that signal's volume can be adjusted with the ZONE 2 Volume control. !3 POWER Indicator The indicator will light when the unit's power is ON. !4 ZONE AFL Select Switch Selects the signal that is sent to the PHONES jack. Press the switch to select either ZONE 1 (?) or ZONE 2 (>). !5 HEADPHONE Volume Controls the signal level that is sent to the PHONES jack. !6 PHONES Jack This is a stereo phone type jack for connecting a pair of headphones (nominal output/impedance of 30mW/ 40Ω). I Attaching the Security Cover The MV800 is supplied with a security cover for channels 1-8, the ST channel, and the compressor and paging sections. If the security cover is needed to protect knobs and switches from being tampered with, attach the security cover after connecting and setting up the microphones and line devices, etc. 1. Attach the post screws to the attachment holes (4 locations) on the front panel. 2. Align the holes in the security cover with the post screws and attach the cover with the set screws. Post screw Front panel Attachment hole Security cover Set screw MV800 - Owner's Manual