Yamaha MV800 Owner's Manual - Page 9
PAGING Input, REC OUT 1L/1R, 2L/2R Jacks, ZONE OUTPUT Jacks, ZONE 1 L/R, POWER Switch
View all Yamaha MV800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Front & Rear Panels 7 • STACK OUT This is an unbalanced phone type output jack with a nominal input/impedance of 0dB/10kΩ. It sends the ZONE 1 and ZONE 2 bus signals that have passed through the compressor circuit. The ZONE 1 signal is sent to the Tip while the ZONE 2 signal is sent to the Ring. When multiple MV800s are connected together, this jack sends the signal to the main MV800. It can also be used to send the signal to an external device. r PAGING Input • MIC/LINE Input Jack Connect the source device (cassette deck, etc.) or microphone that will be used when the paging function is in use. This jack is compatible with 50Ω to 600Ω microphones or 600Ω line level devices. • Input Select Switch Selects the type of microphone or device connected to the MIC/LINE input jack. This switch functions in the same manner as the Input Channel's Input Select Switch q. • CONTROL IN Jack This is the input jack for the emergency announcement system's control signal (DC24V). t REC OUT (1L/1R, 2L/2R) Jacks With an external DAT recorder or cassette recorder connected to these jacks, you can record the same signal that is sent from the ZONE OUT jacks. The signal from ZONE 1 is sent to the 1L and 1R jacks while the ZONE 2 signal is sent to the 2L and 2R jacks. The signal sent from these jacks is not affected by the ZONE volume controls. Make recording level adjustments on the recording device. Also, the ZONE 1 TO 2 switch is ineffective with these jacks. y ZONE OUTPUT Jacks (ZONE 1 L/R, ZONE 2 L/R) These jacks deliver the stereo output of the mixed signal and are connected to a power amplifier, etc. that drives the main speakers. Two types of jacks are provided; balanced XLR type and Euro-block connectors. • XLR type (1: Ground, 2: Hot, 3: Cold) Nominal output/impedance +4dB/600Ω • Euro-block connector ( : Hot, : Cold, G: Ground) Nominal output/impedance +4dB/600Ω u POWER Switch When the switch is in the ON position, the unit is powered. When turning the power ON, first turn on the MV800, then turn on the power amp or powered speakers that are connected to the device. Also, when turning the power OFF, turn off the power amp or powered speakers before turning off the MV800. Connector polarity INPUT, ZONE OUT INSERT IN INSERT OUT STACK IN STACK OUT PHONES Pin 1: ground Pin 2: hot (+) Pin 3: cold (-) Tip: hot (+) Ring: cold (-) Sleeve: ground Tip: ZONE 1 Ring: ZONE 2 Sleeve: ground Tip: L Ring: R Sleeve: ground INPUT OUTPUT Ring Sleeve Tip MV800 - Owner's Manual