Yamaha MX200-16 Owner's Manual - Page 6
Master control AUX SEND 1-4 AFL switches - channel
View all Yamaha MX200-16 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
s Master control section MIXING CONSOLE 1 STEREO ON switch This switch turns the ST OUT output on/off. When this switch is off, levels will not be displayed in the ST meters. The MONO OUT signal will be sent regardless of this switch. 2 STEREO L, R master faders 8 These faders adjust the final level of the combined signals +6 +6 from all channels, and send them from the STEREO OUT +4 +4 +2 +2 connectors. -15 HIGH +15 -15 HIGH +15 0 0 -2 -2 The ST meters allow you to monitor the L and R outputs. -4 -4 -7 -7 -15 LOW +15 -15 LOW +15 -10 -10 -15 -15 3 MONO ON switch This switch turns the MONO OUT on/off. -20 -20 0 AUX 110 0 AUX 210 -00 L ST R 1 AUX 2 -00 MONO PFL/AFL 3 AUX 4 4 MONO AFL switch When this switch is on, the signal being output to MONO 7 6 0 10 LEVEL 0 10 LEVEL AUX RETURN 1 AUX RETURN 2 10 10 5 5 0 0 5 5 10 10 15 15 20 20 30 30 00 00 METER SELECT OUT can be monitored in the headphones. C 5 MONO fader 10 PHANTOM 10 PFL D E This fader adjusts the output level of the MONO OUT connector. 5 5 0 0 5 5 9 6 AUX SEND 1-4 AFL switches 10 10 15 15 0 10 When you wish to monitor the output signals being sent to 20 30 00 20 REC OUT 30 00 0 AUX SEND 1-4, press the appropriate switch. The level of the AUX SEND whose switch is on will be in- 0 10 TAPE IN dicated by the PFL/AFL meter. AFL AFL AFL AFL 3 1 4 AUX SEND 1 AUX SEND 2 AUX SEND 3 AUX SEND 4 ON ON AFL 0 10 PHONES 7 AUX SEND faders A These faders adjust the level of the output signals sent from AUX SEND 1-4. The 8 METER SELECT switch can be set so that these AUX SEND signals are monitored in the level meters. 10 10 10 5 5 5 0 0 0 5 5 5 10 10 10 15 15 15 20 20 20 30 30 30 40 40 40 00 00 00 L ST R 2 MONO 5 PHONES 8 AUX RETURN 1, 2 controls The LEVEL knobs control the level at which signals from effect units etc. connected to the L/MONO, R jacks of B AUX RETURN 1, 2 are sent to the L, R bus. If a plug is inserted into only the L/MONO jack, the same signal will be sent to both L and R buses. The AUX1 knobs control the level at which signals from effect units etc. connected to the L/MONO, R jacks of AUX RETURN 1, 2 are sent to the AUX SEND 1 (2) fader. After being adjusted at the fader, the signal is output from the rear panel AUX SEND 1 (2). This knob is a low frequency equalizer that provides 80Hz shelving equalization of the signal input at AUX RETURN. 4