Yamaha NS 777 Owner's Manual - Page 2
ATTACHING THE STANDS, Procedure - speakers
UPC - 027108916804
View all Yamaha NS 777 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
. ATTACHING THE STANDS When placing the speakers, be sure to use the stands to increase stability. Procedure: 1 First, put the screw through the washer, then through the inner hole of the stand, and screw it into the outside hole of the speaker. Do not tighten too much at this point. Outer hole Inner hole (L) (R) Stand (R x 2, L x 2) Pad x 4 Note Washer x 4 Screw (25mm) x 8 The provided stands are in two types. Two stands are for the right side and others are for the left side. Attach each stand to the proper position on the bottom of the speaker by following the figure below. View from the bottom of the speaker (L) Back (R) 2 Put a screw through the outer hole on the stand, and screw it into the other hole on the base of the speaker. 3 Tighten both of the screws firmly. 4 Attach a pad to the bottom of the end portion of the stand. 5 Attach the other stands to the other corners of the base of the speaker in the same way and confirm that all 4 stands have been firmly attached. (R) (L) Front Use the 8 specified holes located on the base of the speaker. Note Be carefull not to apply force to the side of the speaker, otherwise the speaker may fall causing damage to the speaker or personal injury. 2