Yamaha NS-F700 Owners Manual - Page 3

SUPPLIED ACCESSORIES After unpacking, check that the following parts are contained. (L) (R) Stand (R × 2, L × 2) Screw (6mm (1/4")) × 4 Wood screw (4mm (3/16")) × 4 Pad × 4 ATTACHING THE STANDS When placing the speakers, be sure to use the stands to increase stability. Notes • Make sure to have another person support it. ■ Procedure 1 Put the 6 mm (1/4") screw through the large hole in the stand, and screw it into the speaker at one of the outside holes in the base of the speaker. At this time, screw it in loosely so that the stand can still be moved. 2 Put the 4 mm (3/16") wood screw through the other hole in the stand, and screw it into the other hole in the base of the speaker. 3 Tighten both of the screws firmly. 4 Attach a pad to the bottom of the end portion of the stand. 5 Attach the other stands to the other corners of the base of the speaker in the same way and confirm that all 4 stands have been firmly attached. Pad Screw (6mm (1/4")) Wood screw (4mm (3/16")) • Pay extra attention to avoid scratching on the speaker's surface. • Place the speaker on a supporting surface (height of 5 cm (2") or more). Use a blanket or a cushion on it to avoid scratching. • The provided stands are in two types. Two stands are for the right side and others are for the left side. Attach each stand to the proper position on the bottom of the speaker by following the figure below. • To attach the stands to the speaker, be sure to lay down the speaker with the side facing up. (R) (L) Back Front Note Be carefully not to apply force to the side of the speaker, otherwise the speaker may fall causing damage to the speaker or personal injury. (L) (R) View from the bottom of the speaker Use the 8 specified holes located on the base of the speaker. 1 En English