Yamaha NS-M525 Owners Manual - Page 2

PLACING THE SPEAKERS Place the speakers on a sturdy, vibration-free surface, on a well-built stand. ■ Using as 2ch stereo speakers Better stereo images will be obtained when the speakers are slightly angled in towards the listeners. ■ To mount the speaker on a wall by using the attached mounting bracket Fasten screws into a firm wall or wall support as shown in the figure, and hang the holes of the mounting bracket on the protruding screws. By setting the two supplied bass control plugs into the ports on the rear of the speaker, the tone and volume balance of the low bass sound produced between the port and the wall will be better. * Make sure that the screws are securely caught by the narrow parts of the holes. Tapping screw (3.5-4 mm) (Available at the hardware store) ■ Using as front speakers in a multi channel system Position the speakers on both sides of the TV. The positioning of speakers is important, because it controls the whole sound quality of a multi channel system. Set up the speakers on the basis of your listening position by following the owner's manual supplied with your amplifier. ■ Using as presence or surround speakers Mount the speakers on a wall or place the speakers on a shelf. Determine the best position by following the owner's manual supplied with your amplifier. NS-M525 Presence Subwoofer NS-M525 Center Surround back 3 mm Min. 20 mm 40 mm Wall/ wall support You can also use the screw holes on the rear of the speaker for installing the speaker using a commericially available speaker bracket (if you do not use the attached mounting bracket). Screw holes Diameter: 6 mm Hole depth: 15 mm 60 mm NS-M525 Front NS-M525 Surround Note: This speaker features a magnetically shielded design, but there is still a chance that placing it too close to a TV set might impair picture color or create a buzzing noise. Should this happen, move the speaker away from the TV set. WARNING: • This speaker weighs 4.5 kg (9 lbs.14.7 oz.). Do not mount it on thin plywood or a wall with soft surface material. If mounted, the screws may come out of the flimsy surface and the speaker may fall. This damages the speaker or causes personal injury. • Do not install the speaker to a wall with nails, adhesives, or any other unstable hardware. Longterm use and vibrations may cause it to fall. • To avoid accidents resulting from tripping over loose speaker cable, fix it to the wall. E-2