Yamaha NX-B55 NX-B55 Owners Manual - Page 10

AUTO STANDBY This unit has a function that automatically activates standby mode (power save mode) when no audio signal is input from a connected device, or when the connected device is playing at a low volume for a certain period (about 30 minutes). In standby mode, the indicator light turns off. Activates the auto-standby mode Off 2 On R speaker (Right) Rear panel a Press p (power) to turn off this unit (Power off). b Set the AUTO STANDBY switch to ON. c Press p (power) to turn on this unit. Notes • Auto-standby mode activates when the power is on. • The time it takes to enter standby mode is only a guide, and varies depending on the situation. Auto-power on PLAY Play the connected device in standby mode... In standby mode, if signal is input, the unit turns on and sound is output from the speakers (Auto-power on). Deactivating the auto-standby mode If this unit enters standby mode while you are using it, perform either of the steps below, or . Adjust the volume. a Slightly turn up the volume of the connected device. b Rotate the VOL (volume) control of this unit and adjust to the desired sound level. Set the AUTO STANDBY switch to OFF. Off 2 On a Press p (power) to turn off this unit. b Set the AUTO STANDBY switch on the rear to OFF. c Press p (power) to turn on this unit. Notes • The default setting of the AUTO STANDBY switch is ON. • If this unit is not used for a long time, press p (power) for power off. • To activate auto-standby mode again, set the AUTO STANDBY switch on the rear to ON. Notes • If the volume from a connected device is too low, this unit may not start. In this case, turn up the volume of the connected device. • If a device that emits electromagnetic waves, such as a mobile phone, is used near this unit, the unit may start by itself, or not enter standby mode as a result of input signal noise while making or receiving a phone call. 3 En